Agora H1 User manual

AGORA
43 Avenue de Châtellerault
86440 MIGNE-AUXANCES - FRANCE
H1 - MECHANICAL MOUNTING AND ELECTRICAL SAFETY
To avoid any risk of electrical shock H1 can be only used with mounted side bracket. Agora disclaim any
responsibility in case of use that does not comply with these instructions.
H1 is delivered with mounting brackets and coupling plates. Please read the assembly instructions below.
Package includes:
 20 x Hexa screws M3*5mm
 1 x long bracket
 1 x short racket
 2 x Mounting plates
 2 x Screwdriver
1: Long bracket mounting instructions:
1: insert the plates of the bracket in the reserved spaces on the side of the box
2: screw the 8 x M3*5mm in the designated holes (white circles)
3: Complete by screwing 2 x M3*5mm on the side of the bracket

AGORA
43 Avenue de Châtellerault
86440 MIGNE-AUXANCES - FRANCE
2: Short bracket mounting instructions:
1: insert the plates of the bracket in the reserved spaces on the side of the box
2: screw the 8 x M3*5mm in the designated holes (white circles)
3: Complete by screwing 2 x M3*5mm on the side of the bracket
3: Rack coupling mounting instructions:
1: mount the short brackets on the external sides of the both units (see chapter 2)
2: insert two plates on the upper spaces of the first unit - Screw them with 4 x M3*5mm in the designated holes
(white circles).
3: insert two plates on the lower spaces of the Second unit - Screw them with 4 x M3*5mm in the designated holes
(white circles).
4: pair the two units and fix them by screwing the last screws in the designated holes (white circles)
All support documents can be found at agora-network.fr