AgXcel 18022 User manual

116 E 6TH ST
KEARNEY NE 68847
877.218.1981
www.agxcel.com [email protected]
40 AMP PWM ELECTRIC MOTOR DRIVER
PN# 18022
40 AMP MAXIMUM
(RED OR WHITE)
(BLACK)
The Pump Driver Module (EMD) replaces the servo valve.
System ow is controlled by regulang the pump speed
via a PWM signal to the EMD.
NOTE: This unit will ONLY work with PWM (Pulse Width
Modulated) Control drives. Set the PWM frequency of
your controller to 150 Hz.
MODULE INSTALLATION
Posion the EMD where wiring will work the best.
Extension cables are available. Secure the EMD to the
equipment, fastening with screws, using the holes in
the mounng anges.
ELECTRIC INSTALLATION
This secon explains how to hook-up your EMD to a
12-volt power connecon, and how to connect your
EMD to your controller harness.
The EMD MUST be connected to a 12-volt DC negave
ground electrical system.
POWER BATTERY CONNECTION
Locate the power cable and route to the baery. In rout-
ing cable avoid areas where the cable may be subjected
to abrasion or excessive heat. Aach the BLACK wire to
ground. See Illustraon to the upper right. Be sure there
is a good metal-to-metal contact. Connect the RED (or
WHITE) wire to the posive baery terminal. Connect
the power to the EMD by plugging the 2-Pin M/P 480
Tower on the power cable into the 2-Pin M/P 480 Shroud
of the EMD module.
NOTE: Be sure to route cables away from sharp
edges, areas of high heat and moving parts.
Secure all cables rmly with plasc cable es.
SIGNAL AND MOTOR CONNECTIONS
Connect the other end of the cable to the mang
connector on the controller harness using Adapter
Cable P/N 53556 if required.
Locate the pump cable or “y” harness for dual pump
system. Plug the 2-pin M/P 480 Shroud into the 2-pin
M/P 480 Tower on the EMD module. Connect the other
end to the pump. Insure that the pump is running in the
correct direcon. If not, simply reverse the wires from
the pump to the pump cable.
See Next Page for Applicable Diagram.
LED STATUS INDICATOR CODES
See table on page two for LED status indicator code
explanaons.

LED TROUBLESHOOTING GUIDE
COLOR TIME LINE LED
STATE CONDITION
POWER
GREEN OFF NO POWER (OR LESS THEN 6.8V)
GREEN 1hz
FLASH UNDER VOLTAGE (LESS THAN 10.5V)
GREEN ON SOLID 12V SUPPLIED (POWER ACCEPTIBLE)
PWM
BLUE OFF NO PWM SIGNAL TO THE MODULE
BLUE 1hz
FLASH PWM SIGNAL PRESENT
BLUE ON SOLID MAXIMUM DUTY CYCLE
MOTOR CURRENT
RED OFF NORMAL OPERATION (UNDER MAX)
RED 1hz
FLASH OPEN CIRCUIT CONDITION
RED ON SOLID OVER CURRENT (OUTPUT SHORTED)
TEMP
YELLOW OFF MODULE WITHIN TEMPERATURE RANGE
YELLOW 1hz
FLASH MODULE TEMP IS ELEVATED
YELLOW ON SOLID MODULE AUTO SHUTDOWN FROM TEMP
MOTOR
RUNNING
ORANGE OFF MOTOR IS NOT RUNNING
ORANGE ON SOLID MOTOR IS RUNNING
(RED OR WHITE)
(BLACK)
PN# 17871
PN# 18022
PN# 53556
OUTPUT
EXTENSION
PN# LENGTH
18121 10FT
53665 20FT
53666 30FT
53668 40FT
19631 50FT
53670 60FT
www.agxcel.com [email protected]877.218.1981