Air Et Sante A&S 100 ECO User manual

Air Purifier
A&S 100
ECO
User manual

Dear customer
AIR ET SANTÉ would like to thank you for the trust you place in its air purifiers. As all our
attention is focused on your complete satisfaction, here are a few tips for use.
• Your purifier can be used continuously; in this case we recommend that you keep it in
automatic mode, its smell detector will then control its autonomous functioning.
• Your purifier can be used in manual mode, so you can set it to strong airflow to
quickly purify the air in your room, and then set it back to automatic mode.
YourA&S100is optimized to purify an area of around 40m
2
.It has 6 filtrations
stages :
Pre filter : captures the smallest particles and protects the HEPA filter.
Medical grade HEPA filter : 99.95% efficient on particles larger than or equal to 0.1
µm (PM2.5).
Activated carbon filter: fixes and retains gaseous pollutants (volatile organic
compounds).
Catalysis & photocatalysis : transforms pollutants into carbon dioxide and water
steam.
Photocatalysis and UV : UV lamps activate titanium dioxide and degrade pollutants
into carbon dioxide and water steams.
Negative ions : charged (-) they aggregate with pollutants (+) and cause them to fall
to the ground.

1
Manuel A&S 100 -
Table of contents
Safety advice...........................................1
Precautions before first use....................2
Quick start ...............................................2
Explanations of control ...........................3
Regular maintenance..............................4
Remote control........................................4
Safety advice
Filter’s replacement.................................4
UV lamps replacement ...........................6
Smell detector update.............................6
Malfunctions............................................6
Recycling.................................................7
Maintenance............................................8
• This model of air purifier is designed for domestic use. It is therefore not designed for
industrial environments.
• Make sure to install the air purifier on a flat and stable surface. Leave at least 20
centimeters of space around it so that the air can circulate properly.
• Do not use your air purifier in humid, dusty environments, near heat sources or
near flammable products or materials.
• Do not touch your air purifier with wet hands and do not allow any liquids to get
into it.
• Never cover your air purifier. Never block any part of the air inlet and outlet vents.
• If you plan to stop the appliance for a long period of time, turn it off and unplug it.
• Before maintenance, cleaning or performing any other work on your air purifier,
disconnect the power supply.
• If you are unsure whether your air purifier is working properly, unplug it before
carrying out any other work.
• The warranty of your device will be cancelled in case of improper use or non-
respect of the safety rules.

2
- Manuel A&S 100
Precautions before first use
• Place your air purifier on a flat and stable surface so that the air can circulate easily
(minimum 20 cm all around).
• Do not place your air purifier behind curtains, under a window, under furniture, on
a shelf, or near any other obstacle that may affect its proper functioning.
• Check the condition of the power outlet to which you wish to connect your air
purifier.
• Your air purifier is not suitable for humid rooms such as bathrooms.
• Your air purifier does not replace a kitchen hood.

3
Manuel A&S 100 -
Explanation of controls
Each time a button is activated, the corresponding icon appears on the control
screen.
LED 1: indicates filter’s usage.
ON/OFF: power on/off of the device.
Speed: allows you to adjust the fan's running power by pressing the button
successively. Three speeds are available: high, middle, and low. By default,
when the unit is turned on, the fan power is automatically adjusted according
to the room air quality. The selected speed is indicated on the left side of the
control panel .
Timer: the time button, activates the times and smell detector. The
device automatically adjusts its functioning to the room air quality. The
times can be set from 1 to 12h in one-hour intervals. The power turns off
when the time is up.
Veill Silent: in silent mode, the device automatically switches to low
speed and deactivates the smell detector. Pressing the button again, all
previous settings will restore.
Anion : switches on or off the ion generator.

4
- Manuel A&S 100
Sterilize : activates the UV lamps (for germicides).
Numerical display: indicates the scheduled times for the timer.
Air quality indicator: bad, good.
Regular maintenance
To extend the lifecycle of your filters and to ensure optimal functioning of your air purifier, it
is advised to periodically vacuum the pre-filter (blue). It is recommended to clean the
interior and the grilles of the unit regularly.
Remote control
The remote control allows to operate the air purifier remotely with the same commands as
on the dashboard. For the first use, remove the film that covers the batteries.
Filter’s replacement
When should I replace my filters?
The air quality indicator LEDs stay on, after 1900 hours of operation the time meter
indicates that the filters may need to be replaced. This will depend on your
environment and usage duration. The filters are designed to remain effective
between 6 and 12 months.
The reduction in efficiency of your air purifier is, in any way, a sign that it is necessary
to change the filters.
• HEPA filter (blue in front, white behind):
to change when its color has turned yellow, black, or rusty.
• Activated carbon filter (black in front, silver behind):
to change when its surface is dirty or has a dull color.

5
Manuel A&S 100 -
1- Remove the front cover of the device.
2- Open the two locks to release the used filters.
3- Remove, without shaking, the used filters. Place them in a bag, close it well before
putting it in the trash (read p.7).
4- Place the new filters in place of the ones you removed, making sure to respect the
order.
5- Close the two locks.
6- Put the front cover in place.

6
- Manuel A&S 100
Reset the time counter
After replacing your filters, it is necessary to reset the time counter of your air purifier at
0, follow these steps :
1- Unplug the air purifier.
2- Press the power button for 3 to 5 seconds and then plug in (while still pressing the power
button).
3- Release the on button after the fan has started.
4- Unplug the air purifier once again.
5- Wa it 3 to 5 seconds and plug the purifier back into its power outlet. The time counter
is reset to zero.
UV lamps replacement
This operation should only be performed by a qualified technician. For more information,
visit www.air-et-sante.fr.
Smell detector update
If the air quality indicator remains red while the engine is off, it may be necessary to
reset the smell detector memory:
1- After unplugging the unit for 20 seconds, plug it back in, turn it on, and press the
"ANION" button.
2- Let the purifier run for 15 seconds then start again the operation.

7
Manuel A&S 100 -
Malfunctions
For any questions that are not covered in this manual, a dedicated service is
available via our website at: www.air-et-sante.fr
The appliance does not start:
Verify the power supply.
The volume of air produced seems low:
Verify the cleanliness of the filters.
Make sure that the plastic protection films of the filters have been removed.
Despite a long running time, the air quality does not improve:
Replace the filters.
The LED 1 lamp is switched on:
Reminder to replace filters.
Recycling
What to do with used filters?
When the filters are no longer in use, they do not present any danger to the
inhabitants of the household or to the environment. However, when replacing them,
it is preferable to put them in a garbage bag and tie it up tightly before throwing it
with the regular garbage.
Recycling program AIR ET SANTÉ
Concerned about the environment, AIR ET SANTÉ ensures the recycling of the
machines when they reach their life cycle. You will find on our website all the useful
information to guarantee the optimal recycling of your machine.

8
- Manuel A&S 100
Air quality indicator
Air outlet
Smell detector
(Behind the front cover)
Remote controol
Air inlet