Aircare EXECUTIVE User manual

Read and save these instructions
EXECUTIVE
Everything you need to know about your
ALL 4DTS900 MODELS 1B73369
8/2020

1

a. Cabinet
#4V3487020SLVR
b. Fan assembly
#1B72341R
c. Two end covers (attached to the fan assembly)
#1B72336
d. 1041 Super Wick®
ALL 1041 WICKS
e. 1051 air filter
#1051
f. Float
#1B72087
g. Float support and two screws
SUPPORT #830496 | SCREWS #829815
h. Two water bottles
#1B5060110
i. Two water bottle caps
#1B5060000
j. Four casters
#1B5460100
k. Fill hose
#1B5060140
l. Owner’s manual
#1B73369
LET’S GET YOU UP AND RUNNING
Remove the Executive from its packaging.
You should have:
1
Prefer to see a video?
Watch the EXECUTIVE set-up at
aircareproducts.com/support.
SCAN THE CODE TO THE RIGHT
WITH YOUR PHONE’S CAMERA
aa
bb
dd
ee
kk
jj
ff
ii
hh
gg
ll
cc
cc
If you are missing any parts, or need
replacement parts, call us at 800.547.3888 or
visit our website aircareproducts.com.
♥We hope you love your Executive. 2

Locate the vent on the back of your
Executive. It has a narrow lip along the
top. Your wick is labeled TOP and BACK. With
the back of your wick facing the vent, and the
top facing up, slide the wick down onto the
vent lip until it catches.
Remove everything from the cabinet.
Turn the cabinet over and insert the
casters snugly into the bottom. Just use your
hands! Using tools can crack the cabinet.
3
4
5
Turn the cabinet upright and place the
wide end of the float in the circular
area in the bottom of the cabinet. Slide the
float support down to the bottom and position
the screw tabs over the holes in the cabinet
base. Use a Phillips screwdriver to screw in the
float support. Do not overtighten or use a drill.
2
Install your 1051 air filter by clipping
the filter’s hooks into the slots on
the back of your Executive.
About water additives:
• Do not use essential oils in your Executive.
• Do not use water softeners.
• We recommend our Essick Air Bacteriostat to help inhibit
mold growth.
3
4
3

Put the fan assembly on the cabinet.
Make sure the float makes a solid
connection with the fan switch inside the fan
assembly. The fan switch looks like a small, silver
diving board.
Fill your water bottles, then tighten the
caps with your hands, making sure the
caps are correctly threaded. Do not overfill the
bottles. Your Executive holds 5.7 gallons of water.
7
8
Put your Executive in the most centrally-
located room of your home. It should be
on a level surface against an interior wall. Make
sure it’s at least two inches from the wall so the
humidistat (on the cord) can accurately read your
humidity.
6
More about positioning:
• To maximize humidity circulation, put your unit near a cold air return.
• If you prefer to put your unit in the room where humidity is most
needed, you can! But the humidity won’t circulate as well with this
method.
• Don’t put your humidifier under a window, as condensation may occur.
• Put the unit on the bottom floor of a multi-story home.
Note: Each bottle holds 2.75 gallons per bottle. The right bottle will
empty first, putting .2 gallons of water into the cabinet. At that time, you
can refill the right bottle to get the full 5.7-gallon capacity and maximum
run time.
4