AirLive POE-FSH2422G-390 User manual

1
POE-FSH2422G-390
24-Port Full Power 802.3af PoE
Web Smart Switch
Use
r
’s Manual

Copyright and Disclaimer
AirLive POE-FSH2422G-390 User’s Manual
i
Copyright & Disclaimer
No part of this publication may be reproduced in any form or by any means, whether
electronic, mechanical, photocopying, or recording without the written consent of OvisLink
Corp.
OvisLink Corp. has made the best effort to ensure the accuracy of the information in this
user’s guide. However, we are not liable for the inaccuracies or errors in this guide. Please
use with caution. All information is subject to change without notice
All Trademarks are properties of their respective holders.

Copyright and Disclaimer
AirLive POE-FSH2422G-390 User’s Manual
ii
FCC Statement
Federal Communication Commission Interference Statement This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation. For product available in the USA/Canada market, only
channel 1~11 can be operated. Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction with any
other antenna or transmitter.
IMPORTANT NOTE
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.

Table of Contents
AirLive POE-FSH2422G-390 User’s Manual
iii
Table of Contents
1. Introduction ................................................................................................1
1.1 Overview ...........................................................................................1
1.2 Guide to the Chapters .......................................................................2
1.3 Quick Setup.......................................................................................2
1.4 Installation Steps ...............................................................................3
1.5 Comparison Chart .............................................................................5
2. Installation of the Switch...........................................................................6
2.1 Unpack the Package .........................................................................6
2.2 Hardware Overview...........................................................................7
2.3 Installation Site Preparation ..............................................................8
2.4 Rack Mounting ..................................................................................9
2.5 Desktop Installation .........................................................................10
2.6 Cabling Requirements.....................................................................11
2.7 Connecting to Power.......................................................................12
2.8 Reset to Default ..............................................................................12
3. LED Indicators..........................................................................................14
3.1 Comprehensive LEDs .....................................................................14
3.2 LED Table........................................................................................14
4. Web Management ....................................................................................15
4.1 Setup your computer for Web management ...................................15
4.2 Remote Management......................................................................17
4.3 Get into the Web Management........................................................19
4.4 Administrator ...................................................................................20
4.5 Authentication Configuration (Administrator menu).........................21
4.6 System IP Configuration (Administrator menu) ...............................21
4.7 System Status (Administrator menu) ...............................................22
4.8 Load default setting (Administrator menu).......................................23
4.9 Firmware Update (Administrator menu) ..........................................23

Table of Contents
AirLive POE-FSH2422G-390 User’s Manual
iv
4.10 Reboot Device (Administrator menu) ..............................................24
4.11 Port Management............................................................................24
4.12 Port Configuration (Port Management menu)..................................25
4.13 Port Mirroring (Port Management menu).........................................26
4.14 Bandwidth Control (Port Management menu) .................................27
4.15 Broadcast Storm Control (Port Management menu) .......................28
4.16 POE (Port Management menu) .......................................................29
4.17 VLAN Setting...................................................................................29
4.18 VLAN Mode (VLAN Setting) ............................................................30
4.19 VLAN Member (VLAN Setting) ........................................................31
4.20 Multi to 1 Setting (VLAN Setting).....................................................33
4.21 Per Port Counter .............................................................................33
4.22 Trunking...........................................................................................34
4.23 QoS Setting .....................................................................................35
4.24 Priority Mode (QoS Setting).............................................................35
4.25 Port, 802.1p, IP/DS based (QoS Setting) ........................................36
4.26 TCP/UDP Port Based (QoS Setting) ...............................................36
4.27 Security ...........................................................................................37
4.28 MAC Address Binding (Security) .....................................................37
4.29 TCP/UDP Filter (Security) ...............................................................38
4.30 Spanning Tree .................................................................................39
4.31 STP Bridge Settings (Spanning Tree)..............................................39
4.32 STP Port Settings (Spanning Tree) .................................................40
4.33 Loopback Detection Settings (Spanning Tree) ................................42
4.34 Backup/Recovery ............................................................................42
4.35 Miscellaneous..................................................................................43
4.36 SNMP ..............................................................................................44
4.37 Logout .............................................................................................45
Appendix A: Product Specifications ..........................................................46
Appendix B: Troubleshooting.....................................................................48

1. Introduction
AirLive POE-FSH2422G-390 User’s Manual
1
1 1. Introduction
1.1 Overview
The POE-FSH2422G-390 is a Power Control POE Switch, and total power is 390W. This
switch provides 24 10/100Mbps RJ-45 ports and can support 2 Combo Gigabit RJ-45/SFP
to uplink. This web-smart switch includes auto-MDI/MDIX crossover detection function. 24
of those ports are all built with PoE functionality, providing the ultimate choice in network
flexibility. With this added PoE feature, this switch is an ideal solution for building wireless,
IP surveillance, and VoIP networks.
It also provides port-based and 802.1Q tag VLAN function to provide better traffic
management, reduces latency, improve security and save bandwidth. This is also a
cost-saving feature as it reduces the need to add additional hardware to the network.
These 24 10/100Mbps RJ-45 support the IEEE 802.3af PoE protocol. Each port and
transmit a maximum power 15.4 watts. User can also enable or disable power supply on
PoE ports from UI.
Notice
This switch is using 48V 802.3af PoE standard. It does not work with passive
PoE. Do not connect with passive PoE devices
When plug in the mini-GBIC module, the device will activate mini-GBIC, and the RJ45
port will be disabled.

1. Introduction
AirLive POE-FSH2422G-390 User’s Manual
2
1.2 Guide to the Chapters
Chapter 1
Introduction and Quick Setup guide. All the essential information including IP Address and
Password information are in the Quick Setup section.
Chapter 2
Detail installation instruction including module information and how to make Cat. 5 cable
Chapter 3
LED indicators
Chapter 4
Detail information on Web management including how to setup remote management.
1.3 Quick Setup
This section provides the essential information for experienced users to operate the switch
immediately. For detailed installation instruction, please see chapter 2 for more information.
Power-On the switch
The POE-FSH2422G-390 Switch has a built-in power supply to operate with 100 ~
240V AC, 50 ~ 60Hz power source.
The AC power cord connector is located at the rear of the unit and the On/Off switch is
next to the connector.
After the Switch is powered on, it will perform “self-diagnostic” test. This process takes
about 10 seconds to complete.
It is recommended that you install the switch with an UPS to
protect from potential power surge.
The default password is airlive
This switch is using 48V 802.3af PoE standard. It does not work
with passive PoE. Do not connect with passive PoE devices.
The default IP address: 192.168.2.1
The default username is admin
Important Information

1. Introduction
AirLive POE-FSH2422G-390 User’s Manual
3
LED Table
LED Status Description No. of LED
Power On Power on Power
On Link 1000Mbps
1000M Off Link 10/100Mbps 2 (25~26)
On Link 26 (1~26)
Link/ ACT Flashing Data activating 26 (1~26)
On Port is linked to Power
Device 24 (1~24)
PoE
Off No Power Device is
connected 24 (1~24)
1.4 Installation Steps
This section lists the installation procedures in steps. Each step’s instruction is thoroughly
explained in the subsequent sections of this chapter.
Step 1
Connect your device's PoE port to the switch's POE port (see Figure A). The Gigabit ports
are not PoE ports.

1. Introduction
AirLive POE-FSH2422G-390 User’s Manual
4
Step 2
If you are using a 802.3af compliant splitter with the switch, please install it according to
Figure B.
Step 3
If you want to install the switch on the 19" rack, please install the mounting kit according to
Figure C.
Step 4
Your PoE device should get the power from the switch now. If you want to change
settings via web management. Please follow the instructions below.
Step 5
Set your PC's IP address to 192.168.2.50.
Step 6
Open your web browser and enter "192.168.2.1" to get into the switch's web
management.

1. Introduction
AirLive POE-FSH2422G-390 User’s Manual
5
Step 7
Enter "admin" for username. "airlive" for password.
Step 8
Please check the following chapters for more detailed configurations
1.5 Comparison Chart
Model POE-FSH-2422G-250 POE-FSH2422G-390
Power
Consumption 250 Watts (Max) 390 Watts (Max)
Power Input 100~240V/AC, 50~60Hz
Max supply
PoE Power
per Device
15.4Watts per Port,
250 Watts totally
15.4Watts per Port,
Full Power
Dimensions 445 × 220 × 45 mm
(L x W x H)
440 × 332 × 44 mm
(L x W x H)
Weight 2.54 kg 4.7 kg
Operating
Temperature 0 to 45℃
Storage
Temperature -20 to 90℃
Humidity 10 to 90% RH (non-condensing)
Certifications FCC Class A, CE