airquee Water Drop Operating instructions

Version 1.1 09/12/16
Page 1of 5
Assembly Instructions
Water Drop
IMPORTANT
AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT
YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT.
Included with your Water Drop:
The unit in its bag
Balloons
Rubber Bands
50X
2X

Page 2of 5
Fig. 1
1x
Set up:
The unit is formed of: a metal frame, that will need to be assembled, and a printed sheet.
This unit can be set up and packed away by one person, who has had
proper manual handling training and uses the correct equipment to move
the inflatable.
Installing the metal frame:
The metal frame consists of: –see image bellow
1. The first step is to unpack the pieces of the metal frame. You should start to piece them together
from the bottom.
2. You should place the two legs approximately 2 meters apart on a flat ground. The legs can be seen
in fig.1:

Page 3of 5
Fig. 3
Fig. 2
Fig. 4
3. After the two legs are put the correct distance apart, the next step is to connect the lower metal
frame to the legs as shown at fig. 2.
4. The next step is to connect the upper metal frame to the lower part –as seen in the image below.
5. Now you can insert the water drop cage to the upper left part of the metal frame –as seen below.
By now your metal frame should look like the this:

Page 4of 5
Fig. 7c
Fig. 7b
Fig. 7a
Fig. 6a
Aadfdsf
ds5fhf
Fig. 6b
Fig. 5c
Fig. 5b
Fig. 5a
6. Next you need to assemble the target/bull’s eye and you will need to secure with a bolt in
the middle –see fig. 5a-b-c.
7. Now you can start attaching the banner. You can start attaching the banner from the top of the
frame and go towards the bottom of the frame securing it with the Velcro loops as seen in fig 6a-b.
8. After the banner is fixed on the frame you can fix the outer target ring and fix it with the 3 bolts
provided. Fig. 7a-b-c.
9. Do not forget to secure the metal pole behind the water drop cage with a rubber band, as seen in
fig. 8.

Page 5of 5
Fig. 8
10. Place the water filled balloon into the water drop cage and start aiming at the target.
Disassembling the unit:
The first step is to take the target off, then the sheet, fold it in half (fig.9a), and roll it up so it fits in its bag.
(fig.9b)
Start disassembling the metal frame from top to bottom. First by taking the outer target ring off, and taking
off the metal pieces one by one, exactly in an opposite order of the assembling process.
ENJOY AND HAVE FUN!
Fig. 9b
Fig. 9a