Page 4
O %HFHUWDLQWRUHDGWKLV2SHUDWLQJ0DQXDOLQLWVHQWLUHW\
O'Safety First' for yourself, for others, and for your equipment.
O 2EVHUYH DOO WKH UXOHV RI WKH À\LQJ VLWH RU DQ\ZKHUH \RX
operate your radio control equipment.
OIf at any time during the operation of your model should
you feel or observe erratic operation or abnormality, end
\RXURSHUDWLRQDVTXLFNO\DQGVDIHO\DVSRVVLEOH'2127
operate your model again until you are certain the problem
KDVEHHQFRUUHFWHG7$.(12&+$1&(6
OYour model can cause serious damage or injury, so please
use caution and courtesy at all times.
O 'RQRWH[SRVHWKHUDGLRFRQWUROV\VWHPWRZDWHURUH[FHVVLYH
moisture.
O 3OHDVHZDWHUSURRIWKHreceiver and servos by placing them
LQDZDWHUWLJKWUDGLRER[ZKHQRSHUDWLQJPRGHOERDWV
O ,I \RX KDYH OLWWOH WR QR H[SHULHQFH RSHUDWLQJ PRGHOV ZH
strongly recommend you seek the assistance of experienced
modelers or your local hobby shop for guidance.
O 7KH ORZ YROWDJH DODUP ZLOO VRXQG ZKHQ WKH transmitter
battery voltage drops to 6.7 volts. If this occurs, stop
using the transmitter as soon as possible, then recharge
the transmitter battery. For more information, see page XX.
SAFETY
This radio control system operates on the 2.4GHz frequency band. The 2.4GHz connection is determined by the transmitter
and UHFHLYHUSDLU8QOLNHRUGLQDU\FU\VWDOEDVHGV\VWHPV\RXUPRGHOFDQEHXVHGZLWKRXWIUHTXHQF\FRQWURO
,QDGGLWLRQWRWKH)&&&RPSOLDQFHVHFWLRQRQWKHSUHYLRXVSDJHSOHDVHREVHUYHWKHIROORZLQJVDIHW\DQGXVDJHSUHFDXWLRQV
ZKHQLQVWDOOLQJDQGXVLQJ\RXUQHZ$LUWURQLFV6'**+])+66UDGLRFRQWUROV\VWHP
2.4GHZ FREQUENCY BAND PRECAUTIONS
OThe 2.4GHz frequency band may be used by other devices, or other devices in the immediate area may cause interference on
WKHVDPHIUHTXHQF\EDQG$OZD\VEHIRUHXVHFRQGXFWDEHQFKWHVWWRHQVXUHWKDWWKHVHUYRVRSHUDWHSURSHUO\$OVRFRQGXFW
a range test at the area of operation to ensure that the radio control system has complete control of the model a the farthest
reaches of the operational area.
OThe response speed of the UHFHLYHUFDQEHDIIHFWHGLIXVHGZKHUHPXOWLSOH*+]UDGLRFRQWUROV\VWHPVDUHEHLQJXVHG
WKHUHIRUHFDUHIXOO\FKHFNWKHDUHDEHIRUHXVH$OVRLIUHVSRQVHVHHPVVORZGXULQJXVHGLVFRQWLQXHXVHDVTXLFNO\DVSRVVLEOH
OIf the 2.4GHz frequency band is saturated (too many radio controllers on at once), as a safety precaution, the radio control
V\VWHPPD\QRWELQG7KLVHQVXUHVWKDW\RXUUDGLRFRQWUROV\VWHPGRHVQRWJHWKLWE\LQWHUIHUHQFH2QFHWKHIUHTXHQFLHVKDYH
EHHQFOHDUHGRUWKHVDWXUDWLRQOHYHOKDVGURSSHG\RXUUDGLRFRQWUROV\VWHPVKRXOGEHDEOHWRELQGZLWKRXWDQ\SUREOHPV
O 2EVHUYHDQ\DSSOLFDEOHODZVDQGUHJXODWLRQVLQSODFHDW\RXUÀ\LQJVLWHZKHQXVLQJWKH*+]UDGLRFRQWUROV\VWHP
O 8QOLNHIUHTXHQF\EDQGVXVHGZLWKHDUOLHUUDGLRFRQWUROV\VWHPVUHFHSWLRQZLWKWKLV*+]UDGLRFRQWUROV\VWHPFDQEH
DGYHUVHO\DIIHFWHGE\ODUJHREVWUXFWLRQVDQGFRQFUHWHRUVWHHOVWUXFWXUHVEHWZHHQ\RXUPRGHODQGWKHWUDQVPLWWHU$OVRZLUH
mesh and similar barriers can adversely affect operation. Keep this mind to ensure the safety of your model.
safety and usage precautions
TRANSMITTER PRECAUTIONS
OTurn the WUDQVPLWWHU21¿UVWDQGWKHQWXUQWKHUHFHLYHU21$IWHUXVLQJ\RXUPRGHOWXUQWKHreceiver
2))¿UVWWKHQWXUQWKHWUDQVPLWWHU2)),WFDQEHGDQJHURXVLI\RXDFWLYDWHWKHFRPSRQHQWVLQUHYHUVH
order as the servos may start up inadvertently.
OBefore use, double-check that the transmitter and UHFHLYHUEDWWHULHVDUHVXI¿FLHQWO\FKDUJHG
O 1HYHUWRXFKWKHtransmitter antenna during use. Doing so may cause loss of transmitter output, making
it impossible to control your model.
OBefore use, the transmitter antenna should be pulled up completely and angled
so that the antenna is as close to perpendicular to the ground as possible
during use. After use, to prevent any chance of damaging the antenna, the
DQWHQQDVKRXOGEHORZHUHGDQGPRYHGLQWRWKHKRUL]RQWDOVWRZHGSRVLWLRQ
O 'R QRW H[SRVH WKH WUDQVPLWWHU WR ZDWHU RU
excessive moisture.
ODo not expose the transmitter to excessive heat or direct sunlight.
Leaving the transmitter out in direct sunlight can damage the
LCD Display.
21
2))
Keep Antenna
Perpendicular
to Ground
'R1RW([SRVHWR0RLVWXUH
or Direct Sunlight