Akva Big Box single User manual

Big Box, single
If the bed has drawers on one side only or is designed for a bed with a width of 90,
100 or 120 cm.
•The long side piece is fitted with bench screws and wood dowels.
•The cross pieces are fastened to the side piece with bench screws.
•The two steel beares are screwed into the basic construction.

•The headboard fittings are fitted to the extension pieces (right and left respectively.)
•The extension pieces are fitted to the side and headend pieces.
•Fit the deck plate

Big BOX drawers
•Fasten the castors to the bottom of the drawers with screws using the pre-drilled holes.
(1)
•Assemble the drawers by attaching the drawer backs with the sides using 2 wood
dowels. (2)
•Push the bottom of the drawers into the milling.
(1)
(2)
•Fasten the handles of the drawers from the inside of the drawer with screws (3) and
secure the drawer front with bench screws and 2 wood dowels. (4)
(3)
(4)
•An angle bracket is placed where it
has been marked on the drawer front
and the bottom. This provides stability
to the drawer. (5)
(5)