III
Handling precautions
zConnect “special connector” or “thermocouple miniature connector” applicable to “ASTM
E1684-96 Standard Specification for Miniature Thermocouple Connectors” to the connector port.
Otherwise, malfunction may occur.
zDo not put any foreign object inside the connector port. Otherwise, malfunction may occur.
zLock the battery cover firmly after the replacement of the batteries.
If the packing of the battery case is not in place or if any dust is caught in, the leakage of water may
occur.
zStore it with the batteries removed if this unit is not used for a long period.
Otherwise, the leakage of battery fluid may occur and cause the main unit to malfunction.
zIf a battery is swallowed, serious personal injury may be caused.
Put and keep batteries carefully in a safe place where a child cannot get access to them.
zObserve strictly the cautions stated on the batteries to handle correctly them.
zReplace all of four AA batteries with new ones immediately if the low battery alarm occurs (see
section 1. Starting up).
zThe service life of the battery may vary depending on the service conditions or the brand of the
battery.
zDo not press the display panel or keypad strongly. Otherwise, the display panel or keypad may
break.
zDo not drop the unit or apply any strong impact to it as it is a precise instrument.
zDo not operate this unit under the water.
zKeep this unit away from any equipment producing the strong static electricity or electromagnetic
wave, such as television set, microwave oven, or radio receiver as much as possible.
Otherwise, malfunction or trouble may occur.
zKeep this unit away from any equipment producing the strong high frequency or surge as much as
possible. Otherwise, malfunction or trouble may occur.
zWipe it off lightly with a cloth, which is wrung out with neutral detergent, to clean this unit.
Do not use any solvent, such as benzene, paint thinner, or alcohol, or bleach at any case.
zThis unit has a washable structure (protection grade IP64).
However, if the unit is left with the water splashed for a long time, the water may enter the unit.
Wipe off the unit with a dry cloth rag as soon as possible after washing.
zMount the connector covers, the plug-covers, and battery cover firmly whenever washing.
zRemove the dirt or water content sticking to the sensor or main unit completely, and store them
safely after the measurement.
zDo not operate or store the main unit in a place where the temperature becomes −20℃or less or
55℃or more, or the relative humidity becomes 90% or more.
zDo not operate or store the unit in an environment where there are direct sunlight, or fine particle
dust, or high temperature and humidity, or any corrosive ingredient.
zContact your nearest sales representative or sales office for any after-sale service such as repair.
zDo not stick the sensor protector to a hard substance. Otherwise, the sensor protector may be broken
or bent. Do not bend the protector intentionally. Never use the bent sensor.
zDo not stretch the sensor cable strongly.
Otherwise, the breakage of wiring and malfunction may occur.
