Alder LIFE User manual

WISH Basin Mixer CODE 40092
SAVE MODETM
Phone [phone] | Fax [phone] | Email [e-mail] | Selection Centre 15 Mumford Place, Balcatta WA 6021
Featuring the Exclusive Collection
LIFETM Panel Shower
FOR MORE INFORMATION VISIT
www.aldertapware.com.au
INSTALLATION INSTRUCTIONS
INSTALLATION DETAILS
•Hot and cold-water inlet pressures should be equal
•Inlet pressure 150 –500 Kpa. Note New Building Regulation –
500Kpa maximum operating pressure at any outlet within the
building (Refer AS/NZS 3500.1:2003 Clause 3.34)
• Maximum water temperature 75⁰C
•May not be suitable for use with gravity-fed water heaters, low
and unequal pressure networks, instantaneous water heaters,
tempering valves and thermostatic mixing valves
•Care taken to protect the flow controllers from blockage due to
foreign debris and damage due to male connecting threads
•If it is possible for backflow to occur with the handset, then a
double check valve will need to be installed as required by
AS/NZS 3500 Plumbing & Drainage Code

WISH Basin Mixer CODE 40092
SAVE MODETM
Phone [phone] | Fax [phone] | Email [e-mail] | Selection Centre 15 Mumford Place, Balcatta WA 6021
Featuring the Exclusive Collection
LIFETM Panel Shower
FOR MORE INFORMATION VISIT
www.aldertapware.com.au
INSTALLATION INSTRUCTIONS
NSTALLATION PROCEDURE

WISH Basin Mixer CODE 40092
SAVE MODETM
Phone [phone] | Fax [phone] | Email [e-mail] | Selection Centre 15 Mumford Place, Balcatta WA 6021
Featuring the Exclusive Collection
LIFETM Panel Shower
FOR MORE INFORMATION VISIT
www.aldertapware.com.au
INSTALLATION INSTRUCTIONS
DIAGRAM #1
•Remove top cover from Rain Shower Arm (packed separately)–6 screws
•Secure Rain Shower Arm to Panel Shower Body - 4 nuts & bolts (supplied)
DIAGRAM #2
•Connect Rain Shower to Shower Pipe and seal with Clamp (supplied)
•Replace top cover
•Assemble Handset Holder to Panel Shower Body
DIAGRAM #3
•Recommended 19BP height is 1900mm for typical user height 1800mm –see Man Figure Diagram Page # 1
•If desired user height different to 1800mm, then adjust 19BP height accordingly
•Reduce length of 19BP Shower Outlet to 10-15mm with Nipple Cutter
•Recommended Nipple Cutter –Reliance Worldwide Product Code A60-001
•Front edge of 19BP Shower Outlet is a sealing surface and must be flat and smooth
•Attach Top Wall Bracket at 50mm above the 19BP and Bottom Wall Bracket at 800 below Top Wall Bracket
•Dimension 50mm –from centre line of Wall Bracket Oval Holes to centre of 19BP
•Attach Wall Brackets with screws & plastic plugs (supplied) –6mm masonry drill bit recommended
•Note Laser Markings on Wall Brackets to assist with vertical alignment
•Note Oval Screw Holes in Wall Brackets to assist with horizontal alignment in DIAGRAM #4
DIAGRAM #4
•Test straightness of Wall Brackets with a one metre long Levelling Tool
•If Panel Shower not vertical –adjust Wall Brackets accordingly
DIAGRAM #5
•Assemble Brass Elbow with Loose Nut onto 19 BP Shower Outlet
•Make sure that Brass Elbow points down and can rotate when in the sealed position
•Connect Flexible Connector to Brass Elbow with Loose Nut –tighten with integral yellow spanner
DIAGRAM #6
•Hook Panel Shower onto Wall Brackets –assemble Shower Hose and Handset