Alico CMA DISHMASHINES 180UC Manual
RINSE
INJECTION
DETERGENT
INJECTION
WASH
SENSOR
RINSE
SENSOR
3-2021
180UC
Quick Setup
Instructions
1
STEP
FLOOR DRAIN
1"AIR GAP
Connect the drain hose to wall, not higher than 22
inches, or floor drain. The floor drain must have a
1 inch air gap between drain hose and floor drain.
WALL
DRAIN
WARNING: Electrical and plumbing
connections need to be made by a
qualified service technician and
comply with all available Federal,
State and Local Health, Electrical,
Plumbing and Safety codes.
1/2" WATER INLET
DRAIN VALVE
PUMP DRAIN
MOTOR
LEVELING
LEGS
2
34
4
Connect dishmachine to hot water source,
recommended minimum temperature
140°F. Unit
will
remain in wash cycle until booster heater
temperature reaches
180°F
, then it will advance into
rinse cycle.
3
STEP
When ever possible, remove pump drain if a floor
drain is available near by. Remove drain pipe and
place drain hose on the drain valve and allow
machine to gravity drain.
4
STEP
NEUTRAL
HOT
GROUND
DRAIN HOSE
1
HARD WIRE
FOUR WIRE
POWER SUPPLY
180UC REAR VIEW
NOT MORE
THAN 22"
HEIGHT FROM
FLOOR
BLUE
RED
TUBE
STIFFENER
CHEMICAL
TUBING
5
Insert tube stiffener with chemical tubing into
corresponding chemical dispensers.
5
STEP
BLUE RED
Level dishmachine by adjusting leveling legs.
Dishmachine must be level front and back and
side to side.
2
STEP
WASH TEMP 150
O
-160
O
FINAL RINSE TEMP 180
O
-195
O
POWER
OFF DRAIN START
CYCLE
ON
DISHMACHINES
6
3-20¯1
180UC
Quick Setup
Instructions
WARNING: Electrical and plumbing
connections need to be made by a
qualified service technician and
comply with all available Federal,
State and Local Health, Electrical,
Plumbing and Safety codes.
The Spirit of Excellence
an Ali Group Company
After filling dishwasher for the first time, (CAUTION:
turn power supply off) reconnect the factory
unplugged wire to booster high-limit switch located
behind front panel.
8
STEP
CMA PN: 10130.02
180UC FRONT VIEW
Turn on power, push Fill Button to fill the Booster
Tank on initial start up. Listen for final rinse until
water cascades into scrap trap.
Turn power switch on, press and hold fill switch, fill
to correct level in wash tank.
7
STEP
FILL
Turn power supply back on. Allow machine to heat up
(about 5-15 minutes). Cycle machine by pushing start
switch. Observe “Rinse Cycle” (last 16 seconds of
cycle) must be minimum 180°F. If necessary adjust
the temperature by turning the adjustment stem on
thermostat clockwise to increase.
STEP
9
NOQDUDMS
D@SHMFKDLDMSC@L@FD~
SGD®µGD@SDQLTRSAD
EHKKDCVHSGV@SDQADENQD
SGDGD@SHMFDKDLDMSHR
DMDQFHYDCNQSGHRQD@RNM
SGDHFGHHLHSVHSBGG@R
HMSDMSHNM@KKXADDM
CHRBNMMDBSDC@SSGD
E@BSNQX@MCVHKKQDPTHQD
QD§BNMMDBSHNM
DET
5$
35,0(
¶
7
6
8
STEP
Other Alico Dishwasher manuals
