AllerAir AirMedic Pro 5 HD User manual

GETTING STARTED
Congratulations! You are moments away from fresher, cleaner indoor air. The quick start
instruction guide will aid you in getting your AllerAir unit up and running right away.

To unpack your AllerAir unit, open the top of the box and remove the top foam piece
locking the wheels in place. Gently turn the unit box ( with the air purifier inside )
upside down so that the open part of the box is against the floor. Lift the box up off
the air purifier. The unit is now out of the box in its proper upright position. Plug it
into a grounded 115V outlet and run it on HIGH for a few minutes before choosing
the desired setting.
1
2
Place the unit upside down, so
that the wheels face up.
Using a #2 Philips screwdriver,
remove the four screws that
hold the base onto the unit.
Grab the wheels. Remove the
base by pulling on the wheels.
Locate the two gaskets inside
the unit.
Place one gasket inside the
unit all the way at the bottom.
Place the HEPA & Activated
Carbon filters inside on top of
the gasket.
Place the secound gasket on
top of the filters. Ensure it is
centered with the filters.
Using a #2 Philips screwdriver,
install the four screws to hold the
base onto the unit making sure
the arrow on the sticker lines up
with the unit’s rear seam.
Flip the unit back in its upright
position. Plug it in and run it on
high for a few minutes then set
it to your desired speed.
Quick Start Instruction Guide
NOTE: Models Airmedic Pro 5/6 Plus / HD / Ultra require installation of the filters since they
shipped in separate boxes [Box #1 box contains the unit, boxt #2 contains the filters]. Follow the
instructions below to get your unit up and running.