Allo RemoteControl V2 heavy1 User manual

V2 heavy1
families:
.
INSTRUCTIONS
Visit our Website. www.alloremotecontrol.com
The programming of the functions and times of the unit is carried out through the configuration menus, accessible and searchable
through the 3 buttons placed next to the display of the unit.
By pressing OK button you can access the programming and configuration menus of each individual parameters
By pressing the button you will switch to the next item
By pressing the button you return to the previous item
ACCESS TO MAIN PROGRAMMING MENUS:
Press and hold the OK button until the display shows the desired menu
Release the OK button: the display shows the first item in the sub-men or the options available for the function
Using the buttons select and edit the parameters needed
Visit our website: www.Alloremotecontrol.com

INSTALLATION:
Visit our website: www.Alloremotecontrol.com
Visit our website: www.Alloremotecontrol.com
CAUTION: if you do not carry out any operation for more than 1 minute, the unit exits from the programming mode, without storing the
settings and changes made are lost.
If necessary, you can reset all parameters to their DEFAULT values
TRAVEL LEARNING:
1. Press and hold the OK button until the display shows SET
2. Release the OK button: the display shows
3. To exit the function, select Exit using the and press OK to confirm
4. To start the learning procedure of the travel select Learn through the buttons and and press then OK
5. Press and hold the button to open the door completely
6. Press and hold the button to close the door completely
7. Press the OK button to store the travel and exit the function
Visit our website: www.Alloremotecontrol.com
Visit our website: www.Alloremotecontrol.com