Allo RemoteControl AVIDSEN 104250 BRICO User manual

AVIDSEN 104250 BRICO
First type of receiver
INSTRUCTIONS
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button (RF). Keep it pressed down.
The receiver LED light comes on (L1). Release the button
3. Within the next 10 seconds, press a button on your new remote control, release it. The
receiver LED blinks.
4. Wait 10 seconds.
5. Your new remote control is programmed.
Visit our Website: www.alloremotecontrol.com

Second type of receiver:
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button (RX). Release the
button. The receiver LED comes on. Wait 5 seconds. The receiver LED light turns off.
3. Press a button on your new remote control. Keep it pressed down. The receiver LED
light turns on, Release the button
4. Wait 10 seconds.
5. Your new remote control is programmed
Visit our Website: www.alloremotecontrol.com