ALLSWAGE AC CRIMP TOOL Manual

Allswage UK.
Roebuck Street,
West Bromwich, B70 6RB
Tel: [phone] Fax: [phone]
Email: [email protected]
www.allswageuk.co.uk
AC CRIMP TOOL
MAINTENANCE & INSTRUCTIONS MANUAL

Allswage UK.
Roebuck Street,
West Bromwich, B70 6RB
Tel: [phone] Fax: [phone]
Email: [email protected]
www.allswageuk.co.uk
A. PRE-OPERATION SETUP
1. Open the relief valve to fully recess the piston. Then close tightly.
2. Rotate the yoke fully counter clockwise to bottom out the adapter seat.
3. READY STEADY GO!
Piston
Handle
Yoke
Piston
Top Yoke
Die Set
Valve
Body

Allswage UK.
Roebuck Street,
West Bromwich, B70 6RB
Tel: [phone] Fax: [phone]
Email: [email protected]
www.allswageuk.co.uk
B. OPERATING INSTRUCTIONS
WARNING: Do not actuate the piston without having a hose and fitting in place to crimp. This could
cause damage to the tool. BE CAREFUL not to place hands near any pinch point whilst using this tool!
1. Remove pin and “Open”top yoke.
NOTE: It may be necessary to turn body counter clockwise until top yoke can be rotated away from
piston.
2. Select correct die set.
NOTE: Be sure to use correct size die set! Failure to do so could cause leakage or failure of the crimp!
3. Insert dies into yoke.
4. Position fitting and hose in crimper and close top yoke.
5. Insert pin securely.
NOTE: Make sure pin snaps into place and is secure before crimping process is started.
6. Turn body of tool clockwise until dies are snug against hose fitting.
7. Turn hydraulic valve to “closed”position.
8. Pump handle to crimp fitting onto hose. Continue pumping until handle comes to a stop.
NOTE: Place the body of the tool against a solid body to create more oeverage during the crimping
process.
9. Once crimp is complete, tuern hydraulic valve to “OPEN”position.
10. Turn body of tool counter clockwise until top yoke can be rotated away from piston portion
of yoke.
11. Remove holding pin and open yoke.
12. Remove hose assembly.
WARNING! Wear safety goggles when using the tool.