ALLTEC ExoTHERM User manual

Suitable For Use With All HWE Machines
Powerful Twin Element 2.4kW Heaters
2 Power Levels: 1.2kW & 2.4kW
Adjustable Temperature 0-90°C
Low & High Pressure Safety Cut Out
5m/16ft Power Cable
Fully Serviceable
THE NEW ALLTEC HEAT & RUN BOX
All manuals and user guides at all-guides.com

TheAlltec Heat & Run Box
ExoTHERM
OPERATION INSTRUCTIONS
Set up your hot water extraction ( HWE ) machine ready for
use.
Connect the ExoTHERM either directly to your machine with
the hose supplied, or to the end of an extension hose.
Connect a hose to the ExoTHERM solution outlet ready for
use.
Connect the ExoTherm to a power outlet.
( Extension leads are not recommended, but if absolutely
necessary ensure single socket, heavy duty extension lead
is used. )
Turn on the mains power.
Select low or high heat and set required temperature.
Turn on your HWE machine and set your pressure - for use
with the ExoTherm this should be between 100 - 400psi.
Allow the ExoTHERM to warm up for 60 seconds before use.
Start cleaning and the water will come through hot within a
few moments.
Just before finishing cleaning, turn off the ExoTHERM and
continue cleaning to help reduce the unit ' s temperature to
make it more comfortable to pack away.
All manuals and user guides at all-guides.com

IMPORTANT NOTE - Action required on first use:
Connect the heater as described but before
connecting the power turn on your water pump and
pull the wand / tool trigger until water runs freely
without any air splutter. Thereafter this procedure is
not required unless the unit has sat empty or unused
for a length of time.
Warnings:
Do not allow the unit to freeze, this can damage components
which can be costly to replace / repair.
Optimum water input temperature is 40 ° C, high temperatures
may not allow the thermostat to operate as effectively causing
cooler periods in operation.
If warning LED ' s are lit the unit will not operate, check for too
low or high pressure.
Safety Features:
Low pressure: the unit will not operate without a machine &
water pump connected and turned on.
High pressure: the unit will not operate over 500psi. ( The unit
has been pressure tested to 1200psi however it is designed to
cut out at 500psi for safety reasons. )
Unit will not over - pressurise if left turned on without being
used.
All components in this unit are completely serviceable, we
recommend the unit is returned to Alltec for regular servicing
and electrical testing.
All manuals and user guides at all-guides.com

Alltec Network Ltd
Butts Business Centre
Fowlmere, Royston
Hertfordshire
SG8 7SL
01763 208222
[e-mail]
www.alltec.co.uk
All manuals and user guides at all-guides.com