ALP PS1000i User manual
N-GEN PRONE GENETORS
OWNERS MANUAL
Product Support Product Information, Application, Servicing & Warranty Questions
FEATURES
Notice Regarding Emissions
,
,
,I I�
I/
7
20
22
18
24
13
15
17
ECO Mode Switch
Engine Switch
Running Light
Overload Light
Low Oil Light
LED Emergency Light
DC Circuit Breaker
DC Outlet
USB Outlet
Parallel Power Ports
AC Circuit Breaker
120V 3-Prong Receptacles
ECO Mode Switch
-
Using the Generator for the First Time
& WARNING:
Step
1
Adding
e
ngin
e o
i
l
Your generator is shipped without oil per Federal Law. You need to add 200ml o r 6.7 oz
of oil prior to use
Oil Filler Cap
Figure 2 - Unscrewing the Oil Filler Cap
Figure 1 - Removing the Maintenance
Cover Plate
Figure 3 - Adding Oil
N
N
10
The generator is equipped with an automatic shutoff to protect it from damage due to
low oil. Nonetheless, you should check the oil level of the engine before each use to
ensure that the engine crankcase has a sufficient amount. Running the generator when
the amount of oil is insufficient may severely damage the engine.
Ste
p
2
C
h
e
ck
t
h
e oi
l
l
e
v
e
l
& WARNING:
0
& CAUTION:
Figure 1 Figure 2 Figure 3
&WARNING
AC Usage
& CAUTION:
& CAUTION:
& CAUTION:
& CAUTION:
DC Usage
&WARNING
If on skin: If in eyes:
If swallowed:
Low Oil Level Alarm System
Stopping the Engine
In an emergency:
In normal use:
The Importance of Maintenance
& WARNING:
& Maintenance Safety
& CAUTION:
MAINTENANCE AND CARE (Continued)
Maintenance Schedule
Changing the Oil
& ATTENTION:
MAINTENANCE AND CARE (Continued)
Spark Plug Maintenance
Figure 1 - Removing the Spark Plug Repair Panel Figure 2 - Removing the spark plug cover
Figure 3 - Removing the spark plug Figure 4
MAINTENANCE AND CARE (Continued)
Air Filter Maintenance
& CAUTION:
Figure 5 • Removing the Maintenance Figure 6 • Removing the air filter cover
Cover Plate
Figure 7 • Removing the air filter
Storage and Transportation
& CAUTION:
A
When transporting your generator:
MAINTENANCE AND CARE (Continued)
When long-term storing your generator:
•Make sure the storage area is dry and clean.
•Remove the spark plug (see page 16), pour a tablespoon of clean oil into the cylinder,
rotate the engine a few times to distribute evenly, and then reinstall the spark plug.
•Slowly pull the starter handle until pressure is felt. At this point, the piston is rising to the
end of its compression stroke. The intake and exhaust valves are closed. In this case,
storing the engine helps prevent internal rust.
18
Troubleshooting
Problem Cause Solution
L
h
U
L
19
Generator Specifications - PS1 000i
6.3A
20
Table of contents
Popular Portable Generator manuals by other brands
Campbell Hausfeld
Campbell Hausfeld GN30c502AC operating instructions
Autohaus
Autohaus AHPS-900 instructions
Vitrek
Vitrek Xitron 2000 Series user guide
Toyama
Toyama TG15000CXE owner's manual
MTS Systems
MTS Systems SilentFlo 505G2 Series manual
HGI Generators
HGI Generators KUMS080HAE1X004 Operation & maintenance manual
