Alpha Fan Heritage User manual

Model : Heritage

IMPORTANT : PLEASE READ BEFORE INSTALLATION
1. Installation must be carried out by a qualified wiring installer.
2. Turn off the electrical mains at the circuit breaker fuse box.
3. Do not use power supply other than 240V~ 50Hz.
4. The appliance must be permanently connected to the electricity supply through a double pole switch
having a contact separation of at least 3 mm in all poles.
5. Do not connect ceiling fan to any dimmer switch or regulator.
6. When mounting the fan, ensure that the safety wire is loop across the ceiling mounting hook.
7. The ceiling mounting hook must be able to withhold a min. of
35 lbs / 16 kg.
8. The ceiling fan must be mounted at a min. height of 8.2 ft / 2.5 m of clearance from the floor and
3 ft / 1 m from the wall to the blade.
9. Do not install at areas/places near/at
a) chemicals and alkali
b) flammable area such as gas cooker
c) oily places
d) wet and high humidity area such as shower room
e) high vibration/impact and continuously expose to direct wind
10. Do not place any objects in the path of the blades.
11. When all electrical connections are done, store all wires neatly.
12. Make sure that all screws and connection are tighten till snug.
13. The appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction.
14. Children should be supervised to ensure that they do not play with the appliance.
TABLE OF CONTENT
Warning
Note
This product is designed to use only those parts supplied with this product and/or accessories designated
specifically for use with this product. Using parts and/or accessories not designated for use with this product
could result in personal injury or property damage.
The illustrations in this manual are for explanation purposes only and may differ from the actual unit. It is
subjected to change without prior notice for further improvements.

Step 4
Remove the safety wire screw and washer from the
downrod.
Step 3
Remove the bolt and rubber pulley from the
downrod and place it onto the ceiling mounting hook.

Step 5
Firmly screw the safety wire with washer onto
the dowrod.
Step 4
Tie the safety wire across the hook as shown.

Step 7
a) Connect the brown, blue and orange wires from the receiver to the fan.
b) Connect the red, white and green wires from the receiver to house’s supply wire.
Step 8
Remove the screws at the motor and fix the blades to motor using these screws.
IMPORTANT : ASSEMBLE THE BLADES ONLY AFTER THE CEILING FAN IS MOUNTED ON THE HOOK.

Step 9
Install the decorative screw to the fan.

POWER SUPPLY CONNECTION
IMPORTANT : DO NOT CONNECT THIS REMOTE CONTROL CEILING FAN TO REGULATOR OR
DIMMER SWITCH.

240V~ 50Hz