Altina A8330 User manual

User’s Manual in English
English Version
R02
Oct. 2008
Trademarks
All brand and product names are trademarks or registered trademarks of their
respective companies.
Note
The information in this manual is subject to change without notice.

1
Before You Start
※Precautions and Notices
※For your own safety, do not operate the controls of the product while
driving.
※Use this product prudently. The product is intended to be used only as a
navigation aid. It is not for precise measurement of direction, distance,
location or topography.
※The calculated route is for reference only. It is the user’s responsibility
to follow the traffic signs and local regulations along the roads.
※When you get off the car, do not leave your device on the dashboard
that is subject to direct sunlight. The overheating of the battery can
cause malfunction and/or danger.
※GPS is operated by the United States government, which is solely
responsible for the performance of GPS. Any change to the GPS
system can affect the accuracy of all GPS equipments.
※GPS satellite signals cannot pass through solid materials (except glass).
When you are inside a tunnel or building, GPS positioning is not
available.
※A minimum of 4 GPS satellite signals is needed to determine current
GPS position. Signal reception can be affected by situations such as
bad weather or dense overhead obstacles (e.g. trees and tall buildings).
※The wireless devices might interfere the reception of satellite signals
and cause the reception of the signal to be unstable. For better signal
reception, it is recommended that you use a car antenna (option).
※A car holder is needed when using the device in a car. It is
recommended that you place the device in an appropriate place, so as
not to obstruct the driver’s view, or deployment of airbags.
※When battery run out, the device will automatically turn off the power.
So, when plug-in the car charger or power adaptor, please reset the
ON/OFF switch to re-initiate the device.

2
※Overview
GPS Navigation Features
※ Electronic maps with roads, freeways, highways, railways, rivers, lakes,
points of interest, etc.
※ GPS positioning
※ Optimal route calculation and trip plan
※ Friendly and efficient navigation with turn-by-turn, voice, and visual
guidance
※ Various ways for searching a location on the map
- Using a known address
- Using a POI (point of interest)
- Using Favorites (personal stored locations)
- Using History (previous destinations)
※ Recording and playback of journeys
※ Real-Time Traffic Information System
※ Viewing modes for different needs and situations:
- 2D or 3D
- Daytime or nighttime view
- Turn-by-turn view of the route
- Driving direction of the route

3
Other Features
※ Audio Player
※ Photo Viewer
※ Movie Player
※ EBook
※ Calculator
About this Manual
This manual is divided into four major parts:
※Part I “Basic Operations” tells you how to get your device running and
customize system settings.
※ Part II “Media” introduces Music Player, Photo Viewer, Video Player
and E-Book.
※Part III “ Hands Free Calling”
※ How to use the navigation? Please see Navigation Manual attached to
the package and CD.

4
Part I. Basic Operations
Part I guides you through the process of getting your device running, familiarizes
you with the external components, and tells you how to customize system
settings

5
1. Getting Start
This chapter tells you step by step how to perform the initial startup and
introduces you to the external components of your device.
1.1 Understanding Hardware Features
Note: Depending upon the specific model purchased, the color and ID may not exactly
match the device shown in this manual.
Top and back Components

6
1.2 Performing the Initial Start up
Using the stylus slide the ON/OFF switch to the ON place. Then the device will
be turned on automatically.
Note: Always leave the ON/OFF switch in the ON status for normal operation.
It is strongly recommended that charge your GPS device completely before use
it at first time.
The main menu appears shown as below:

7
1.3 Connecting to AC/USB Power and Charging
the Battery
Connect the adapter cable to your device and plug the AC adapter (optional) into
a wall outlet or charge the device via connecting USB cable to computer. When
charging the battery for the first time, you should charge it for a couple of hours.
NOTE:
● Depending on your region of purchase, the connector converter may not look
exactly the same as the picture shown.
● Do not disconnect your device from AC power until the battery is fully
charged. This will take a couple of hours.
zIf you will not use the product for a long period of time, be sure to fully
charge the battery at least once every two weeks. Over discharge of the
battery can affect the charging performance.
zThe AC/USB adapter is optional accessory.

8
1.4 Using Your Device in a Vehicle
Using the Car Holder
※CAUTION:
1. Select an appropriate location for the car holder. Never place the holder
where the driver’s field of vision is blocked.
2. If the car’s windshield is tinted with a reflective coating, an external
antenna (optional) may be needed to route the antenna to the top of the
car through a window. When closing the car window, be careful not to pinch
the antenna cable. (Cars with an anti-jam window design may
automatically leave adequate space as needed.)
NOTE: Depending upon the specific model purchased, the car holder supplied with your
device may not look exactly the same as the picture shown.
Notes for Use in a Vehicle
● Take care that the holder does not present any risk to safety, even in the case
of an accident, when installing it.
● Take care that the holder does not impede any safety components.
● The display of your navigation system may show “light re-flexions”. Please
take care of not being “blinded” during operation.
● Do not mount the components within the operating range of any airbags.
● Check the secure adherence of the suction cup at regular intervals.
● The power plug will consume power, even if no device is connected. Remove
it when not in use to avoid draining the battery.
● Check all safety equipment in your car after installation.

9
Connecting the Car Charger
The car charger supplies power to your device when you are using the device in
a car.
※CAUTION : To protect your device against sudden surges in current,
connect the car charger only after the car engine has been
started.
NOTE: Depending upon the specific model purchased, the car holder supplied with your
device may not look exactly the same as the picture shown.
1. Connect one end of the car charger to the power connector of your device.
2. Connect the other end to the cigarette lighter in the car to power and
charge your device and ensure that it will not lose contact while driving.
This could cause a malfunction.
● Hint: Remove the power adapter from the cigarette lighter socket when
ending a trip or when parking the car for an extended period of time.

10
2. Setting
This chapter guides you through the process of using your device and
familiarizes you with the basic operations such as using the stylus pen and
navigation pad.
2.1 Turning on and off Your Device
1. Insert the supplied SD card (optional) into the slot at the bottom of device.
2. Push the Power button, the device will open, if push the button again, the
device will off.
Note: When you press the power button to turn off the device, it actually enters a suspend
state and the system stops operating. Once you turn on the system again, it resumes.
3. The Main Menu appears as shown below. You can now use your device.
For the Navigation please see Navigation Manual attached to the package and
CD.
※Fully charge the battery before using your device for the first time is
recommended.

11
2.2 System Setting
Your device is supplied with default settings. You may customize the settings to
suit your personal needs. Once you change settings, your new settings will
remain until either you change them again, or until battery cut off switch is turned
off and then back on again, which resets the unit to factory defaults.
Inserting a SD/MMC Card
Your device has a SD/MMC slot where you can insert an optional Secure
Digital or Multi Media Card storage card. To use a SD/MMC card, insert it into the
slot, with the connector pointing to the slot and its label facing the front of the
device. To remove a card, first make sure that no application is accessing the
card, then slightly push the top edge of the card to release it and pull it out of the
slot.

12
Using System Settings
Tap the System button on the main menu.
To open the Settings menu, first tap the Settings button shown as below:
2.2.1. Language
Tap arrow to select the language you want.

13
2.2.2 Time& Date
1. Tap theDate/Time button on the Device Settings menu. The Date/Time
Function menu appears as shown below.
2. Tap the date button to enter into the date menu.
3. Tap the time button to enter into the time menu.

14
4. Tap the time zone to select the time zone.
2.2.3 Volume
Tap the Audio button on the Device Settings menu. The volume Function menu
appears as shown below.
Tap arrows to adjust the volume.
2.2.4 Backlight
Tap arrows to adjust the volume.

15
2.2.5 System Information
Factory Reset
Return to the default setting
Calibration
You can calibrate the touch screen if it is not responding accurately to your
Taps.
1. Tap the About buttonon the Device Settings menu. The About Function
menu appears as shown below .
2. Tap the Calibration button on the About Function menu. The Calibration
Function menu appears as shown below.
3. Tap and hold the centre of the target.
When the target moves to another position, tap and hold at the center of the new
target. Repeat each time to complete the calibration process. When completed,
tap anywhere on the screen.
2.2.6 Gps. Info
This page shows the satellite receiving status.

16
Part II. Media
Part II introduces Music Player, Picture Viewer, Movie Player, EBook
and Calculator.

17
3.Using Music Playback
3.1 Starting Music Player
This chapter introduces you how to play music files with your device
The Music Player Program turns your device into a Music Player.
It features:
zPlayback of Music files
zBasic playback controls such as play, pause, stop, next audio profiles
zPlayback includes single selection playback, repeat, single repeat, sampling
playback, normal sequence and random sequence
zPlay list support
Tap the music player icon on the Main screen as shown below.

18
3.2 Preparing Music Files for Your Device
Before you can play music files, you need to have the files ready on a storge
card and insert your card into your GPS device. The program will search for the
files in your storage card, when the files are detected, they will be added to the
play list.
3.3 Music Playback Control
Tap one of the Music files, the control panel of the Music player will appear on
the screen where you can easily control the player by tapping the control buttons;
and the selecting Music start playing.

19
4.Using Photo Viewer
This chapter tells you how to play Photo files using your device
The program turns your device into a Photo player. It features:
※Playback of JPEG files
※Basic playback controls such as the picture with zoom in/out, rotation in full
screen.
4.1 Starting Photo Player
Tap Video Player on the media page to switch to the program.