ambiance Inspiration 29 User manual

MODEL: UF0500-1
UF0510-1
GAS FIRED DIRECT VENT
FIREPLACE INSERT
S/N 601327 AND UP
ARCHGARD FIREPLACE PRODUCTS
7116 Beatty Drive
Mission, BC V2V 6B4 Canada 200-0500-12
June 03, 2019
English and French Installation Manuals available through your
local dealer or visit our website at: www.archgard.com
Les manuels d'installation en anglais et en français son
disponibles chez votre détaillant local ou en visitant notre site
web: www.archgard.com
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
This appliance may be installed in an aftermarket
permanently located, manufactured home (USA only) or
mobile home where not prohibited by local codes.
This appliance is only for use with the type of gas indicated
on the rating plate. This appliance is not convertible for use
WARNING: If the information in these instructions is not
property damage, personal injury or loss of life.
INSTALLATION, OPERATION, AND
MAINTENANCE MANUAL
liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance
• Do not touch any electrical switch; do not use any phone in
your building
• Immediately call your gas supplier from a neighbors phone.
• Follow the gas suppliers instructions
•
department
installer, service agency or the gas supplier.
WARNING: If the information in this manual is not followed
damage, personal injury or loss of life.
Inspiration 29
71.93%
Based on CSA P.4.1-15

2
TABLE OF CONTENTS
1.0 Introduction 3
2.0 Safety Information 4
3.0 Technical Information 5
5
5
5
5
4.0 Rating Plate 6
5.0 Installation Checklist 7
6.0 Appliance Overview 8
8
6.2 Appliance Overview 8
6.3 Leveling the Appliance 8
9
9
7.0 Electrical Connections 9
8.0 Appliance Dimensions 10
9.0 Minimum Opening Dimensions 11
12
13
10.0 Clearances to Combustibles 14
10.1 Mantel Clearances 14
14
10.3 Hearth Clearances 15
11.0 Gas Connections 16
16
12.0 Conversion Kit Instructions 17
12.1 Prepare the Fireplace 17
17
18
18
13.0 Venting Instructions 19
20
20
22
23
14.0 Barrier Screen Installation 24
15.0 Glass Door Installation 25
25
16.0 Surround Installation 26
27
17.0 Firebox Liner Installation 28
28
29
30
18.0 Media Installation 31
31
35
36
19.0 Operation 37
37
19.2 First Fire 37
38
39
40
20.0 Maintenance 47
47
48
48
48
49
50
20.7 Replacing Fuse 50
51
52
53
54
55
20.13 Replacing the Fan 56
57
59
60
21.0 Frequently Asked Questions 61
22.0 Replacement Parts List 62
Warranty Information 65
65
66

3
General Information
1.0 Introduction
The UF0500-1 UF0510-1
UF0500-1 UF0510-1 are:
•
•
•
•
•
•
•
•
Section 19.4
•
Settings
CPI vs IPI:
Continuous Pilot on Demand Ignition (CPI)
Intermittent Pilot Ignition (IPI)
Please complete and submit the warranty registration card included in the back of this manual or by visiting us at:
www.archgard.com/warranty-registration

4
General Information
2.0 Safety Information
Caution
FOR YOUR SAFETY
Safety
WARNING:
California Proposition 65 Warning:
Section 5.0
Any alteration to the product that causes carbon or soot deposits that results in any damage or requires
cleaning is not the responsibility of the manufacturer.

5
General Information
3.0 Technical Information
Section 4.0.
Commonwealth of Massachusetts
Archgard Industries Ltd
3.2 Installation Codes
National Fireplace Institute® (NFI) as NFI Gas Specialists.
Natural Gas (NG) Propane (LP)
Manifold Pressure
Min. Supply Pressure
Max Supply Pressure
Input Rating
71.93% 71.93%
78.95% 78.95%
Electrical Rating
Gas Control
Altitude
Primary Air Opening FULLY OPEN
3.4 High Altitude Installation

6
General Information
4.0 Rating Plate
LISTED VENTED GAS FIREPLACE HEATER and GAS-FIRED APPLIANCES FOR USE AT HIGH ALTITUDES. Tested to: ANSI

7
Installation
5.0 Installation Checklist
This standard installation checklist is to be used by the installer in conjunction with, not instead of, the instructions contained
within this installation manual.
Customer: Date Installed:
Install Address: Location of Fireplace:
Installer:
Solid Fuel Zero Clearance Install: (Section 9.1) YES NO IF NO, WHY NOT?
Venting: (Section 13.0) YES NO IF NO, WHY NOT?
clearances.
Wiring / Electrical: (Section 7.0) YES NO IF NO, WHY NOT?
Gas: (Section 11.0) YES NO IF NO, WHY NOT?
Finishing: YES NO IF NO, WHY NOT?
Figure 9.0.02
Appliance Setup: YES NO IF NO, WHY NOT?
Comments:

8
Installation
6.0 Appliance Overview
6.1 Rating Plate Location
Figure 6.1.01:
6.2 Appliance Overview
Note:
Figure
6.2.01.
6.3 Leveling the Appliance
Figure 6.2.01:
Figure 6.3.01:

9
Installation
7.0 Electrical Connections
CAUTION:
NOTE:
6.4 Accessing the Control Board
1. Section 16.0
2. Figure 6.4.01.
Figure 6.4.01:
6.5 Relocating Controls and Valve
Valve Relocate:
1. Section 16.0
2. Section 20.12
3.
4.
Control Board Relocate:
1. Section 16.0
2.
3.
4.
5.
6.
Remove and
discard
Reinstall
valve here
Figure 6.5.01: Figure 6.5.02:
Figure 6.5.03:

10
Installation
8.0 Appliance Dimensions
Front View
Left Side Right Side
Top

11
Installation
9.0 Minimum Opening Dimensions
Figure 9.0.02.
Section 9.1.
WARNING:
AVERTISSEMENT:
Figure 9.0.02:
AB
C
D
E
F
G
Reference Dimension
Controls Forward Controls Rear
A
C
Figure 9.0.01:
WARNING:

12
Installation
9.1 Factory Built Fireplaces
The following information applies to Factory Built (metal) Wood-Burning Fireplace installations:
Figure 9.0.02
Under no circumstance can it be placed directly on a combustible material.
Figure 9.1.01:
Fireplace.
Figure 9.1.02: Removing the Metal Floor
Clearance

13
Installation
9.2 Refacing a Masonry Fireplace
Using Steel Studs and Cement Board on Wood Fireplaces
WARNING:
WARNING:
.
Steel Studs
Wood Burning / Masonry
fireplace
Sealant to be used to avoid heat from
entering enclosure
Sealant
all areas of the wood burning
firebox must be sealed to avoid heat
entering any cavities.
Use Cement Board on front and around
Steel Stud enclosure and where needed to
ensure no heat enters any cavities.
Figure 9.2.01:

14
Installation
10.0 Clearances to Combustibles
WARNING:
CAUTION:
Figure 10.1.01
10.1 Mantel Clearances
10.2 Sidewall Clearances
Figure 10.2.01
10"
12"
14"
16"
18"
20"
7" 7"
19.2"

15
Installation
10.3 Hearth Clearances
16"
Figure 10.3.02
3"
WARNING
NOTE
16"
Non Combustible
Zone
30.5"
Figure 10.3.01

16
Installation
11.0 Gas Connections
Section 4.0 Section 6.1
appliance’s gas valve.
All gas connections must be
checked for gas leaks.
CAUTION:
Natural Gas Pressure Settings:
Propane Pressure Settings:
11.1 Clocking Procedure
IMPORTANT:
Rough Calculation Equation:
1 / Time to burn 1ft³ of gas in seconds / 3600 x gas caloric value in BTU/ft³ = Rating

17
Installation
12.0 Conversion Kit Instructions
IMPORTANT:
WARNING:
IMPORTANT:
UA1000 UA1100
•
•
•
•
WARNING: SHUT OFF GAS SUPPLY AND ELECTRICAL POWER TO FIREPLACE
SHUT OFF GAS SUPPLY BEFORE DISCONNECTING ELECTRICAL POWER
12.1 Prepare the Fireplace
12.2 Pilot Conversion
Figure 12.1.01:
Figure 12.2.01:

18
Installation
12.4 Complete the Conversion
•
•
•
• all
Section 11.0
Section 11.1
•
• Section 6.1
•
•
12.3 Convert the Gas Valve
WARNING:
•
•
•
•
1.
2. See Figure 12.3.01
3.
Figure 12.3.02
Figure 12.3.02.
4.
Figure 12.3.03 Figure 12.3.04
Figure 12.3.05
5.
REPLACE
6.
7.
8.
9.
WARNING: Installation should be carried out in a clean environment.
WARNING: This modulating conversion kit must ONLY be applied as part of a conversion kit supplied by the APPLIANCE
MANUFACTURER.
WARNING: Correct operation of the system cannot be guaranteed if the conversion kit or valve has been dropped or has
sustained a strong impact.
INSTALLER NOTICE: These instructions must be left with appliance.
Figure 12.3.01:Figure 12.3.05:
Figure 12.3.03:
Figure 12.3.02:
Figure 12.3.04:

19
Installation
13.0 Venting Instructions
WARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result
separate solid fuel burning appliance.
CAUTION
The Air intake and Exhaust connections are marked on the gas
appliance. See Figure 13.1.01.
DO NOT REVERSE THESE CONNECTIONS
CAUTION
Figure 13.0.01
Exhaust
Figure 13.0.02: Figure 13.0.03:
Sealing the Vent
DO NOT

20
Installation
13.2 Approved Venting
Archgard Venting Components
Vent Component Part Number
Figure 13.1.04: Figure 13.1.05:
Figure 13.1.06:
13.1 Vent Restrictor Installation