Amer.com SD5 User manual

SD5 5-Port Dual-Speed Mini
Switch
User’s Guide
Version 1.0
P/N: ATISD5030314
This User's Guide contains important information
regarding the installation of your switch. Please read it
completely before beginning installation.
For future reference, record the serial number
of your network switch in the space below:
SERIAL number
The serial number is located on the bottom of the switch.
Amer.com
7259 Bryan Dairy Road, Largo, FL 33777
© Amer.com Corp., 1997-2002 All rights reserved.
No part of this publication may be reproduced in any
form or by any means or used to make any derivative
such as translation, transformation, or adaptation
without permission from Amer.com, as stipulated by the
United States Copyright Act of 1976.
Amer.com reserves the right to make changes to this
document and the products which it describes without
notice. Amer.com shall not be liable for technical or
editorial errors or omissions made herein; nor for
incidental or consequential damages resulting from the
furnishing, performance, or use of this material.
Amer.com is a registered trademark of Amer.com. All
other trademarks and trade names are properties of
their owners.
FCC Class B Certification Statement
Model SD5 FCC Class B
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If the equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment
and receiver.
•Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected to.
•Consult the dealer or an experienced radio/TV
technician for help.
Shielded interface cables must be used in order to
comply with emission limits. You are cautioned that
changes or modifications not expressly approved by
the party responsible for compliance could void your
authority to operate the equipment. For more
information please contact the Federal Communication
Commission.
CE Mark Class B Statement In a domestic
environment, this product may cause radio interference
in which case the user may be required to take
adequate measures.

Package Contents
zOne SD5 5-Port 10/100M Ethernet Switch
zOne AC Power Adapter
zThis Quick Installation Guide
Congratulations on your purchase of the 5-Port 10/100M Mini Switch.
This switch integrates 100Mbps Fast Ethernet and 10Mbps Ethernet
network capabilities in a highly flexible mini package.
Ports 1-5 At the rear site of the Switch, ports 1-5 are where you will
connect your Computers to the Switch
Power At the left site of the Switch, the power port is where you
will connect the AC power adapter. Be sure to only use the
AC power adapter that came with the Switch.
The 5 UTP/STP ports support automatic
MDI/MDIX crossover detection function
gives true ‘plug and play’capability, with
the Auto-MDI function, you just need to
plug-in the network cable to the switch
directly and no need to care if the end node
is NIC (Network Interface Card) or switches and hubs.
Connect the Switch’s AC power adapter to the Switch’s
Power port. Plug the other end of the adapter into an AC
outlet. When connected the AC power adapter to the
switch’s Power port and AC outlet will immediately
power on this Switch.
When the Switch installation was completed, check on the LED
indicators for the status.
POWER This indicator lights green when the switch is receiving
power.
Link/ACT This indicator lights green when the port is connected to a
station. The indicator blinks when transmitting or
receiving data on the network.
Standards IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3x Full-duplex flow control
Ports 5 x UTP/STPAuto-MDIX ports
Transfer Rate Ethernet 10Mbps/20Mbps
Fast Ethernet 100Mbps/200Mbps
Performance Non-blocking full wire speed
Power 7.5VDC/1A
EMI FCC Class B/CE Mark B/VCCI-B

Amer.com Warranty Policy
Limited Lifetime Warranty
In the event of a defect in quality or workmanship,
Amer.com will repair or replace any hardware product sold
by Amer.com with new or reconditioned parts free of charge
in North America for a limited lifetime period unless
otherwise specified on the sales invoice from the date of
original purchase. All removed parts become the property
of Amer.com. All replaced parts assume the original
warranty.
This warranty is extended only to the original purchaser.
Proof of purchase will be required before warranty service is
provided.
This warranty covers only failures due to defects in quality
or workmanship that occur during normal use. It does not
cover damage that occurs in shipment, electrical storms,
floods, dropped or other acts of nature.
This warranty also does not cover any failure that results
from accident, misuse, abuse, neglect, mishandling,
misapplication, alteration, faulty installation, modification,
computer virus, improperly installed or faulty software, or
service by anyone other than an Amer.com Service
Technician. If there is evidence that the failure was due to
user negligence, Amer.com has the right to void this
warranty and or charge normal service rates for the subject
repair.
The limited warranty covers a one (1) year period from date
of purchase on Power Supplies, AC Adapters & Fans, after
the 1 year a cost for replacement is applied to all products
requiring such parts.
Amer.com is not responsible for any type of data loss on hard
drive or other storage devices.
Warranty Service can be obtained during the warranty period
by shipping, freight prepaid, or delivering the product to
Amer.com in either the original package or a similar package
providing an equal degree of protection. Amer.com will
perform the required service and return the unit to the user
(freight prepaid), if applicable, via the same mode (i.e.
ground, air, etc.)
Limits and Expectations
There are no express warranties except as listed above.
Network products by Amer.com shall not be liable for
incidental or consequential damages resulting from the use of
this product. Any future upgrades, including (but not
limited to) hardware and software are not covered by this
limited warranty. If a hardware problem with this product
develops during the warranty period, you may contact the
Amer.com Service Center at:
Telephone [phone]
Facsimile [phone]
Service Center
Amer.com
7259 Bryan Dairy Road
Largo, Florida
33777
U.S.A.