American Standard FFAS1401-101501BF0 Installation instructions

6
Installation & Operation Instructions
Single Hole Basin Mixer (without pop-up drain)
Parts List
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Handle
Cap
Screw
Cap
Nut
Cartridge
Body
Shank
Washer
Washer
Washer
Nut
Hose（Red）
Hose（Blue）
Washer
Aerator
Aerator Housing
Knob
Pop－Up Rod
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
5
FFAS1401-101501BF0 (WF-1401.101.50.1)
Test / Usage
4
Cold
ON
Hot Installation & Operation Instructions
2
3
4
5
Concept
Concept
1
2
3
4
5
6
7
8
9
10
11
12
13 14
15
16
17
18
19
1
Dimension & Maintenance
Trouble Shooting
Untwist the hose.
Checkpoint Contents Action
Cartridge packing
Hose junction Check the connection.
Check cartridge install.
Check valve position.
Check any impurities. Remove all impurities.
Open it to full valve
When packing is damaged, replace the cartridge.
Check the existence of packing and wind it up sufficiently
Trouble
Poor flow rate
Leakage
Water supply valve
Flexible hose
Aerator
Check if hose is twisted.
Check if the water from angle valve is enough or not
Check if the supply pipe connected correct or not Connect the hot and cold water pipe correctly
Increase water supply
Deviant
Temperature Supply system
Thank you for selecting American-Standard - the benchmark of
fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please read
these instructions carefully before you begin.
* Move handle down into “off” position.
Turn on supply angle valve to check all
connections for leak.
* Operate handle up and down, left and
right to flush water lines thoroughly.
Test Usage
No. Part Name Q'ty
Aerator
* AERATOR may accumulate dirt causing distorted and
reduced water flow. Remove and clean AERATOR and
then replace it.
* If faucet drips, operate handle several times from "off"
to "on" Do not apply excessive force.
* Clogged CARTRIDGE inlets may cause reduced flow
in "full on" hot or cold water. To clean inlets, first close
supply water , then:
1. Close Supply Water.
2. Open up faucet. (Reference picure)
3. Clean faucet or change component.
4. Reinstall.
Concept
Concept
Attention:
Please Leave the manual to the customer
after installation is finished.
/A0
Single Hole Basin Mixer (without pop-up drain)
FFAS1401-101501BF0 (WF-1401.101.50.1)

Installation
13
2
1
2
3
4
5
Hot
Cold
DIMENSION
* Recommended water pressure condition: 0.1~0.5Mpa.
* Environment Temperature: 1~55℃
* Not for use as a steam outlet.
* The cold and hot water pipes must not be changed.
Conditions for use
6
Note
Concept
Concept
35 ±3
50
G1/2”
410 111.3
Max 25
105
43
Hose(red)
Hose(blue)
Water Supply Valve
(Provided by customer)
Water Supply Valve
(Hot) Water Supply Valve
(Cold)
Installation Hole
Single Hole Basin Mixer (without pop-up drain)
FFAS1401-101501BF0 (WF-1401.101.50.1)