American Weigh Scales RBS-330 User manual

AMERICAN WEIGH
SCALES INC.
USER’S MANUAL
RBS-330
330lb x 0.2lb /
150kg x 0.1kg

American Weigh
RBS-330 User’s Manual
330lb x 0.2lb
Thank you for purchasing the RBS-330 Round Bathroom Scale. With
normal care and proper treatment, it will provide you with years of
reliable service. Please read all operating instructions carefully before
using the scale.
•Avoid any exposure to extreme heat or cold. Your scale will work
better when operating in normal room temperature. Always allow the
scale to acclimate to normal room temperature for at least an hour
before use.
•Give the scale sufcient warm up time before use. Usually 30 to 60
seconds to give the internal components time to stablize.
•Keep your scale in a clean environment. Dust, dirt, moisture, vibra-
tion, air currents, or a close proximity to other electronic equipment can
cause an adverse effect on the reliability and accuracy of your scale.
• Handle with care. Gently apply all items to be weighed onto the
weighing surface. Although this scale is designed to be quite durable,
avoid rough treatment as this may permanently damage the internal
sensor.
• Do not shake, drop, or otherwise shock the scale. This is a precision
instrument and must be handled with extreme care.
• Only operate the scale on a stable, vibration free surface.
• Always store in a dry place to avoid moisture accumulation on
internal components.

Parts Description
1. LCD Display
2. Tempered Glass
3. LB/KG Switch
4. Scale foot
5. 9V Battery Compartment
I. Setup
Remove the main unit from the package. Insert a 9V battery
(included) into the battery compartment (see above). You are
now ready to weigh!
Top
Bottom
5
1
2
3
4

II. Weighing
Scale may not turn on if weight is applied too slow.
In this case, you can tap the scale at any time to turn
the display on.
1. The scale is ready to weigh at any time.
3. Step onto the scale and wait for the readout to stabilize.
4. The weight will be displayed on the LCD
5. After 10 seconds, the scale will turn off (Auto-Off)
6. Replace the battery if “LO” is displayed on the LCD.
III. Mode Selection (See prev. page for button locations)
1. Flip the scale upside down and locate the LB/KG button.
2. Press the LB/KG button to switch between metric or imperial
weighing modes. (Note the change on the LCD)
3. Set the scale right-side-up again when mode is selected.
IV. Specications
Capacity: 330lb ; 150kg
Graduation: 0.2lb; 0.1kg
Units: pounds (lb) ; kilograms (kg)
Display: 4 digits 1” in height