American TIM-48 User manual

REV 01/17/20
WARNING:
Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety
rules and other basic safety precautions may result in serious personal injury.
Save these instructions in a safe place and on hand so that they can be read when required.
Keep these instructions to assist in future servicing.
TIM-48 Non-metered Control Valve
(Rigid extension with Automatic tip)
Superior Technology at an Affordable Price®

GENERAL SAFETY REGULATIONS
WARNING: The warnings, cautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions or situations that could occur. It
must be understood by the operator that common
sense and caution are factors that cannot be built into
this product, but must be supplied by the operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in
injury.
2. Keep children away from work area. Do not allow children to handle this
product.
3. Use the right tool for the job. Do not attempt to force small equipment to do
the work of larger industrial equipment. There are certain applications for
which this equipment was designed. It will do the job better and more safely
at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it Was not intended.
4. Check for damaged parts. Before using this product, carefully check that it
will operate properly and perform its intended function. Check for damaged
parts and any other conditions that may affect the operation of this product.
Replace damaged or worn parts immediately.
5. Do not overreach. Keep proper footing and balance at all times to prevent
tripping, falling, back injury, etc.
6. DO NOT use the equipment when tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating this
equipment may result in serious personal injury

TECHNICAL DETAILS
INSTALLATION
Precaution Before Installation:
1. Check if the trigger can work normally. Verify trigger operation.
2. Verify that the nozzle assembly rotates.
1. Installation: Apply Teflon tape and pipe dope to the hose threads.
2. Usage instruction:
(1). Squeeze the trigger to start the flow of oil.
(2). To lock the Trigger:
Squeeze the trigger, push the lock forward and release the trigger.
E1
Item No.
Inlet connection
Flow Range
Pressure Range
Temperature
Viscosity
Compatible fluids
TIM-48
3/4” NPT (F)
1～80L/M (0.3～21gpm)
5～100Bar/70-1450psi
Max. 60°C/140°F
8-5000mPas
Engine oils, hydraulic fluid, automatic transmission fluid etc.

（3）Finish:
a. If the lock is not used, release the trigger to stop the flow of oil.
b. If the lock is used, squeeze the trigger to release the
lock and then release the trigger to stop the flow of oil.
Periodic Maintenance: Remove inlet swivel and check inlet filter screen for debris. Remove
spring clip and clean filter as required.
E2