Ameriwood HOME Aaron 9448196PCOM User manual

B349448196COM00UD
Do Not Return This Product!
Contact our customer service team for help rst
Call: 1-800-489-3351 (toll free)
Monday-Friday 9am - 5pm CST
Visit: www.ameriwoodhome.com
–Unit can p over causing severe injury or death.
–Anchor unit to stud in wall (if instructed to)
–Do not allow children climb on unit
–Put heavy items on lower shelves or drawers
Aaron Lane Bookcase
9448196PCOM
Date of Purchase: ____/____/_____
Lot Number:
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
WARNING
Easy Tough
Assembly Diculty Meter
Follow Ameriwood Home

Contact Us!
Helpful Hints
Do NOT return this product!
Contact our friendly customer service team rst for help
Call us!
1-800-489-3351
Monday-Friday
9am - 5pm CST
PEOPLE NEEDED FOR ASSEMBLY: 1-2
ESTIMATED ASSEMBLY TIME: 1 HOUR
Visit ameriwoodhome.com
Assembly Tips
2
ameriwoodhome.com
- Open your item in the area you plan to keep it for less heavy liing
- Idenfy, sort and count the parts before aempng assembly
- Compression dowels are tapped in with a hammer
- Slides are labeled with a R (right) and L (le) for proper placement
- Make sure to always face the point on the top of the Cam Lock towards the
outer edge
- Use all the nails provided for the back panel and spread them out equally
- Back Panel must be used to make sure your unit is sturdy
- Do NOT use harsh chemicals or abrasive cleaners on this item
- Never push, pull, or drag your furniture

Before You Start
Cam Lock Fastening System
3
ameriwoodhome.com
P
P
P
P
P
This Cam Lock Fastening System will be used throughout the assembly process.
Read through each step carefully and follow the proper order
Separate and count all your parts and hardware
Give yourself enough room for the assembly process
Have the following tools: Flat Head Screwdriver, #2 Phillips Head
Screwdriver and Hammer
Cauon: If using a power drill or power screwdriver for screwing,
please be aware to slow down and stop when screw is ght.
Failure to do so may result in stripping the screw.
Quick
Tip
Assembly
1
3
2
4

Board Idencaon
Not actual size
4
ameriwoodhome.com
x1
T9448196020UD
LEFT SIDE PANEL
x1
T9448196030UD
RIGHT SIDE PANEL
x1
T9448196010UD
TOP PANEL
x1
T9448196040UD
BOTTOM PANEL
x1
T9448196050UD
FIXED SHELF
1
5
2 3
4
x2
T9448196060UD
ADJUSTABLE SHELF
6
7
x1
T9448196070UD
LEFT DOOR

Board Idencaon
Not actual size
5
ameriwoodhome.com
x1
T9448196080UD
RIGHT DOOR
x1
T9448196090UD
BACK PANEL
x4
T9448196100UD
FOOT
x1
T9448196110UD
MIDDLE FOOT
8 9
10 11

Part List
Not Actual Size
6
ameriwoodhome.com
x34
TUD0006
NAIL
x8
TUD0002
CAM LOCK
15-12
x12
TUD0004
DOWEL
8X25
Hardware Bag Reference Number:
29448196PCOM0UD
x8
TUD0001
CAM BOLT
x4
TUD0042
FLAT WASHER
x4
TUD0048
BARREL NUT
x4
TUD0075
JCBC SCREW
M6 X 60mm
x8
TUD0028
SHELF HOLDER
x1
TUD0026
ALLEN KEY
M4
x1 set
TUD0021
ANTI TIPPING KIT
x8
TUD0074
CAM LOCK COVER
(STICKER)

7
ameriwoodhome.com
* raw edges are shaded
Step 1
x4
TUD0001
1

x1
TUD0021

8
ameriwoodhome.com
* raw edges are shaded
Step 2
x8
TUD0004
x4
TUD0001
2
3

9
ameriwoodhome.com
Proper orientation of CAM LOCK
Tip
Assembly
Quick
* raw edges are shaded
Step 3
x4
TUD0002
2
3
5
x4
TUD0004
Finished Edging

10
ameriwoodhome.com
* raw edges are shaded
Step 4
x4
TUD0020
x4
TUD0048
x4
TUD0042 x1 TUD0026
2
3
5
4

Insert Barrel Nut and parallel the trip



11
ameriwoodhome.com
* raw edges are shaded
Step 5
2
3
5
4
10
10
11

below shown.

12
ameriwoodhome.com
* raw edges are shaded
Step 6
1
2
3
5
4
x4
TUD0002 x8
TUD0074




13
ameriwoodhome.com
* raw edges are shaded
Step 7
x34
TUD0006

Ensure that the unit is square.
Distance from corner to corner must be equal as shown.
90

be sure that the unit is at 90
Marking for nail.
9

14
ameriwoodhome.com
* raw edges are shaded
Step 8
x8
TUD0028
3
2
6
6

15
ameriwoodhome.com
* raw edges are shaded
Step 9

this screw,
-rotate this screw to the right, the roller will
come out more and the door will be up.

in more and the door will be down.
Sliding door dis-assemble process
Sliding door assemble process
LEFT DOOR
LEFT DOOR
TOP PANEL TOP PANEL TOP PANEL TOP PANEL TOP PANEL TOP PANEL
TOP PANEL TOP PANEL TOP PANEL
RIGHT DOOR
LEFT DOOR
RIGHT DOOR
LEFT DOOR RIGHT
DOOR
LEFT DOOR
LEFT DOOR
DOOR DOOR
RIGHT DOOR
RIGHT
DOOR
BOTTOM
PANEL BOTTOM PANEL BOTTOM PANEL BOTTOM PANEL BOTTOM PANEL BOTTOM PANEL
BOTTOM
PANEL
BOTTOM
PANEL
BOTTOM
PANEL
WARNING


16
ameriwoodhome.com
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER.
FOLLOW THESE INSTRUCTIONS TO INSTALL THE ANTI-TIPPING SAFETY BRACKET
PROVIDED WITH THIS PRODUCT.
WARNING
Serious or fatal crushing injuries
can occur from furniture p over.
To prevent p over:
* Install pover restraint provided
* place heaviest items in the lowest
drawers
* Unless specically designed to
accommodate, do not set TVs or
other heavy objects on the top of
this product
* Never allow children to climb or
hang on drawers, door, or shelves
* Never open more than one drawer
at a me
Use of p over restraints may only
reduce, but not eliminate the risk
of p over
hole
stud
wallboard
OPTION 1: Aachment into a wall stud (preferred method)
Using a stud nder, locate a stud in the wall. Place your unit against the wall, with the safety bracket
aligned in this locaon.
To make driving the screw easier, you can drill a 1/8” diameter pilot hole (3mm) through the safety
bracket into the stud.
Drive the screw through the safety bracket into the wall stud. Tighten the screw that was not fully
ghened in step 5.
OPTION 2: Aachment into drywall
Locate your unit where desired against a wall and mark the wall through the safety bracket, then
move your unit aside.
Drill a 3/16” diameter hole (5mm) into the wallboard. Tap the wall anchor into the hole unl it is ush.
Move your unit into locaon and fasten the wall bracket to the wall anchor with the screw.
Tighten the screw that was not fully ghtened in step 5.
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to securely
aach the safety bracket.

17
ameriwoodhome.com
Maximum Loads
This unit has been designed to support the maximum loads shown. Exceeding these load limits
could cause sagging, instability, product collapse, and/or serious injury.
1. This cercate applies to Dorel Home Furnishings, Inc. product idened by this instrucon manual.
2. This cercate applies to compliance of this product with the CPSC Ban on Lead-Containing Paint ( 16 CFR 1303).
3. This product is distributed by:
4. Site of Manufacturer: Muar, Malaysia.
5. See front page of instrucon manual for date of manufacturer.
Dorel Home Furnishings, Inc.
410 East First Street South,
Wright City, MO 63390
636-745-3351
Cercate of Conrmity
Warning: Please make sure that all the objects are removed before moving the assembled unit.
The unit must be lied by more than one person, not dragged or pushed. Failure to do so will
cause product damage, instability, product collapse, and/or serious injury.
ENJOY YOUR FUNITURE
0 lbs.
0 kg
20 lbs.
9.1 kg
20 lbs.
9.1 kg
20 lbs.
9.1 kg
30 lbs.
13.6 kg

18
ameriwoodhome.com
Register your product to receive the following:
* New trend details -sneak peek on what's new
* Surveys -have a voice within our community
* Exclusive deals and discount codes
* Quick and easy replacement part service
To register your product, visit
Visit your local retailer's website, rate your purchased
product and leave us some feedback!
We would like to extend a big "Thank You" to all of
our customers for taking the to assemble this
Seeds product, and to give us your valuable
feedback.
To register your product, visit Ameriwoodhome.com
We would like to extend a big “Thank You” to all
of our customers for taking the time to assemble
this Ameriwood Home product, and to give us your
valuable feedback

19
ameriwoodhome.com
* raw edges are shaded
Español
Cubierta Delantera

para referencia en el futuro.

obtener
ayuda.

Visitar: www.ameriwoodhome.com
PRECAUCION
Este mueble puede volcarse y causar graves heridas y/o muerte.
Anclar el mueble a un poste de madera en la pared (si esto se requiere).
No Permita que los niños monten el mueble.






- Asegúrese de que siempre este el punto locaizado en la parte superior de bloqueador de leva
este volteadohacia borde exterior





-Lea cuidadosamente cada paso y siga el orden correcto
-Separar y contar todas sus piezas y hardware

-Tenga las siguientes herramientas: destornillador de cabeza plana, #2 cabeza Phillips


asegúrese
que deje de atornillar cuando el tonillos este apretado. Fallar hacer esto puede causar barrer el tornillo


 
Tamaño no real

Lista de
Tamaño no real

20
ameriwoodhome.com
* raw edges are shaded
Español

Paso 1


Paso 2

Paso 3
Borde terminado

Paso 4

inferior.


Paso 5


Paso 6


Cubra Cam Lock con adhesivo

Paso 7
Panel posterior adjunto como se muestra.
Asegúrese de que la unidad sea cuadrada.
La distancia de esquina a esquina debe ser igual como se muestra
Marcado de uñas


Paso 8

Paso 9
Proceso de ensamblaje de puertas correderas
Proceso de desmontaje de puerta corredera.
ADVERTENCIA



