Ametek Reichert 13778 User manual

Reichert®Phoroptor® VRx & SightChek™
Wireless Dongle Kit 13778
For use with ClearChart®4, 4X, 4P or AcuityChek™
Reichert, Inc.
www.reichert.com • 3362 Walden Avenue, Suite 100, Depew, NY 14043 USA
Toll Free: 888-849-8955 • Tel: [phone] • Fax: [phone]
13778-101 Rev. C (August 16, 2018)
©2018 AMETEK, Inc & Reichert, Inc. Bluetooth trademark is owned by Bluetooth SIG.

Wireless Dongle Kit Contains:
Welcome to the Reichert®Phoroptor®VRx & SightChek™Wireless Dongle
Kit 13778, allowing Bluetooth®wireless connectivity between the Phoroptor
VRx or the SightChek and a ClearChart®4, ClearChart 4X, ClearChart 4P
or AcuityChek™.
NOTE: This document will familiarize you with your new accessory. To use this
Wireless Dongle you must rst congure it to communicate with the Phoroptor VRx
or SightChek. Please refer to the Phoroptor VRx Digital Refraction System User’s
Guide (16241-101) or the SightChek Digital Phoroptor User’s Guide (16290-101) for
complete installation, conguration, and compliance information. To obtain a copy of
the User’s Guides, please contact Reichert, your Reichert authorized dealer, or you
may download it from the product page at www.reichert.com. Actual components may
di󰀨er in appearance from those depicted here.
Wireless Dongle
Wireless Dongle AC-Power Supply
w/ Plug Adapter
Wireless Dongle DB9 Programming
Cable
Wireless Dongle USB Power Cable
Serial Extension Cable
0.76 m (2.5 ft)
Hook and Loop Fastener
3
1
2
4
5
6
1
2
36
5
4

Connecting ClearChart 4, 4X, 4P and AcuityChek:
The serial port (A) on the rear of the device is where the Wireless Dongle
(B) will connect. The Extension Cable is used to run the Wireless
Dongle to a location hidden from view, such as the back of the instrument
or the wall. A Hook and Loop Fastener is provided to hide the dongle
from view, by adhering the Wireless Dongle to the desired location either
on the wall or on the back of the unit.
Connect the Dongle (A) to the Serial Cable.
Dongle and Serial Cable Connected
A
Connect the Serial Cable to the Serial Port (B) on the bottom of the unit.
ClearChart 4 Serial Port
B
ClearChart 4 w/ Cable Installed
Serial Cable to Dongle

Connecting ClearChart 4, 4X, 4P and AcuityChek:
(Continued from inside)
The Wireless Dongle will need to be powered by the Wireless Dongle
USB Power Cable (C) via one of the USB ports (D). Connect the
Wireless Dongle USB Power Cable (C) to the Dongle, then connect the
other end to the ClearChart 4.
NOTE: It doesn’t matter which USB port is being used. Either one will power the Dongle.
ClearChart 4 USB Port
D
Dongle Velcro
Dongle Attached to Back
E
The Wireless Dongle Kit comes with a
hook and loop fastener so that the Dongle
can be hidden on either the back of the
unit or on the wall. Attach one side of the
hook and loop fastener (E) to the back of
the Dongle. Then, place the other half on
either the back of the unit or onto the wall,
and attach the Dongle so that it is hidden
from view.
C