Amino Kamai 7Q User manual
3 6 75421
Power/Activity LED:
Blue = on.
Blue ashing = infra-red (IR) command received.
Red = standby.
Wi-Fi signal strength indicator.
Warning! Before connecting or disconnecting the
Kamai 7Q to your TV using any kind of cable, rst
switch o the Kamai 7Q, the TV and all other devices
connected to it (A/V ampliers etc.) and disconnect
them from the mains electrical supply.
You have a choice of ways to connect the audio and
video produced by the Kamai 7Q to your TV:
1. HDMI: Recommended for best quality. Connect a
HDMI cable from the HDMI output of the Kamai 7Q
to the HDMI input of your TV.
2. Analog A/V: Provides good quality in SD only.
Composite video with analog audio left/right.
Connect the 3.5mm jack to the analogue A/V output
on the Kamai 7Q. Connect the yellow RCA plug to
the yellow video port on your TV. Connect the red
and white RCA plugs to the red and white audio
ports on your TV.
Connecting your television directly to the audio/video
output of your Set Top Box will assure a more vivid
picture and enhance your viewing enjoyment.
1. Reset button. This has no function in normal use.
Only use under guidance from your service provider.
2. Analogue A/V output.
3. S/PDIF optical output.
4. Ethernet port.
5. HDMI output.
6. USB port.
7. DC power input 12 V 2 A.
Contents
Your Kamai 7Q is supplied with the correct power
adapter for your region. Depending on the choices
made by your service provider, your box may also
contain the optional accessories shown below.
The Kamai 7Q is protected with a clear plastic lm.
This should be removed before use.
Optional accessories
Overview of the Kamai 7Q
1. Connecting the Kamai 7Q to a TV
Kamai 7Q User Guide
Connect one end of an optical S/PDIF cable to the S/
PDIF optical output of the Kamai 7Q. Connect the other
end to the S/PDIF optical input of your A/V amplier or
home cinema system.
3. Connecting the Kamai 7Q to power supply
Warning! The Kamai 7Q must only be used with the
power adapter provided with the product. Ensure you
have the right power adapter for your region. If you are
unsure, contact your service provider.
Connect the power adapter to the DC power input of
the Kamai 7Q, then insert the power adapter plug into
the mains supply.
2. Connecting the Kamai 7Q to an A/V
amplifier
Remote control and batteries
HDMI cable
Ethernet cable
3.5 mm jack to
3 x RCA cable
Product disposal information - EU only
Amino products are labelled in accordance with the WEEE
Directive and therefore should not be disposed of with
other household or commercial waste. For residential
users: please remove any batteries and dispose of them
and the product in accordance with your local authority’s
recycling processes. For further information please contact your
local authority or the retailer where the product was purchased.
For business users: business users should contact their supplier
and check the terms and conditions of the purchase contract and
ensure that the product is not mixed with other commercial waste
for disposal.
Industry Canada statement
This device complies with ISED’s licence-exempt RSSs. Operation is
subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. le dispositif ne doit pas produire de brouillage préjudiciable, et
2. ce dispositif doit accepter tout brouillage reçu, y compris
un brouillage susceptible de provoquer un fonctionnement
indésirable.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20 cm between
the radiator and your body.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux
rayonnements ISED établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé avec un minimum de 20
cm de distance entre la source de rayonnement et votre corps.
FCC statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation of the device.
IMPORTANT NOTE:
RF exposure warning statement:
1. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
2. This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20
centimetres between the radiator and your body.
Important - Safety instructions
Read these instructions carefully. Note all warnings and keep this
leaet for future reference.
The product contains no user-serviceable parts. Refer all servicing
to qualied service personnel.
Handle the product with care and do not attempt to dismantle it.
Do not expose the product or its accessories to any liquids, rain or
moisture.
The product will become warm during operation. Do not locate the
product near a heat source and do not block ventilation holes. Allow
at least 10 cm (4”) space around the product for air circulation.
Do not put the product in locations where it may be subject to
physical shock, vibration or where it may fall over.
Do not place the product on soft furnishings or carpets.
Only use the power supply provided by the manufacturer. The
use of any other type of power supply may be dangerous and may
invalidate any approval or warranty. If the power supply is not
suitable for your region, please contact the service provider that
supplied it.
Protect the power supply cord from damage.
To disconnect the product from mains electricity, remove the power
supply cord.
Disconnect the product from the mains supply during electrical
storms, or if it is to be left unused for long periods of time.
Disconnect the product before cleaning. Use only a dry cloth.
The product should only be used with attachments and accessories
specied by the product manufacturer.
The product is for indoor use only.
99-708804-71 Rev. 01-02
Hereby, Amino Communications Ltd. declares that the radio
equipment type IP Digital set-top box
is in compliance with Directive 2014/53/EU.
The full text of the EU Declaration of Conformity
is available upon request.
Support and regulatory information
European Approvals
2011/65/EU (RoHS Directive)
The terms HDMI and HDMI High-Denition Multimedia Interface,
and the HDMI Logo are trademarks or registered trademarks of
HDMI Licensing LLC in the United States and other countries.
Manufactured under licence from Dolby Laboratories.
Dolby, Dolby Audio, and the double-D symbol are
trademarks of Dolby Laboratories.
This product contains technology subject to certain intellectual
property rights of Microsoft. Use or distribution of this technology
outside of this product is prohibited without the appropriate
license(s) from Microsoft.
For support and further regulatory information about this product is
available upon request.
Manufacturer/importer: Amino Communications Ltd,
1010 Cambourne Business Park, Cambourne, Cambridge,
CB23 6DP, United Kingdom.
Declaration of Conformity
Other Amino TV Receiver manuals
