AMP HSD1 User manual

For Technical Support, Contact AMP
at [phone] (9 am - 5 pm PST)
or [e-mail]
Connect amplier RF output SMA connector to antenna
Connect the RF output from the CDT1 video transmitter to
RF input SMA connector.
STEP
STEP
STEP
Note When setting up your system, the transmit and receive
antennas should be greater than 25 feet apart to
prevent serious damage to or destruction of the
receiver’s front end
HSD1 Power Amplifier Quick Start Guide
Connect power, Communications (if required), and
enable inputs to the MDM-9P connector *see reverse side
All manuals and user guides at all-guides.com
all-guides.com

AQS-HSD1-B
Advanced Microwave Products
8748 Technology Way
Reno, NV 89521
Phone: [phone]
How to Congure Your Amplier
The HSD1 power amplier does not require any conguring unless it includes optional variable
output level. If included, the power level is set via commands using the Comm port. See the HSD1
Interface Control Document (ICD) for more details.
SMA Female
RF Input
SMA Female
RF Output
Wiring Your HSD1 Power Amplier
MDM-9P
Power & Conguration
1:
2:
3:
4:
5:
6:
7:
8:
9:
+11 to 16 VDC Input
Ground
Ground
Ground
Enable (Open=On, Ground (or <1.5 Vdc)=O)
NC/Tx Comm-
Tx Comm+
Rx Comm+
NC/Rx Comm-
1 5
6 9
All manuals and user guides at all-guides.com