AMP HSF1 User manual

For Technical Support, Contact AMP
at [phone] (9 am - 5 pm PST)
or [e-mail]
Connect amplier RF output SMA connector to antenna
Verify the connected transmitter’s output power is less
than the maximum input power rating (noted on HSF1
chassis) of the HSF1 power amplier, then connect the RF
output from transmitter to RF input SMA connector.
STEP
STEP Connect power, RF power select (if applicable), and
enable inputs to the Hirose DF13 connector *see
reverse side
STEP
Note When setting up your system, the transmit and receive
antennas should be greater than 25 feet apart to
prevent serious damage to or destruction of the
receiver’s front end
HSF1 Power Amplier Quick Start Guide

AQS-HSF1-D
Advanced Microwave Products
PO Box 1437
2465 Old Highway 40 West, Suite 200
Verdi, NV 89439
How to Congure Your Amplier
The HSF1 power amplier does not require any conguring unless it includes optional multiple RF
power output levels. If included, the power level is set using the green and blue wires shown above.
Reference the Output Power Conguration table below to determine whether each wire is to be left
open (or driven to 3.3 Vdc by an external device) or grounded (or driven to below 0.6 Vdc by an
external device) to command the unit to the desired output level. If the HSF1 power amplier is
commanded to a power level with which the unit is not equipped, the unit will default to standby
(disabled) until a valid power level command is applied. See the product manual for more details.
Power Select 1 Power Select 2 Output Power
Ground Ground 250 mW
Ground Open 500 mW
Open Ground 1 Watt
Open Open 2 Watts
Output Power Conguration
Wiring Your HSF1 Power Amplier
SMA Female
RF Input
SMA Female
RF Output
Hirose DF13
Power & Conguration
1:
2:
3:
4:
5:
6:
7:
8:
+11 to 16 VDC Input
Ground
Power Select 1 (Open=High, Ground (or <0.6 Vdc)=O )
Ground
Power Select 2 (Open=High, Ground (or <0.6 Vdc)=O )
Ground
Ground
Enable (Open=On, Ground (or <1.5 Vdc)=O)
Red
Black
Green
Green/White
Blue
Blue/White
Black
White