AMP HSN1 User manual

For Technical Support, Contact AMP
at [phone] (9 am - 5 pm PST)
or [e-mail]
Connect amplier RF output SMA connector to antenna
Connect the RF output from the CNT1 video transmitter to
RF input SMA connector.
STEP
STEP
STEP
Note When setting up your system, the transmit and receive
antennas should be greater than 25 feet apart to
prevent serious damage to or destruction of the
receiver’s front end
HSN1 Power Amplier Quick Start Guide
Connect power, Communications (if required), and
enable inputs to the MDM-9P connector *see reverse side
All manuals and user guides at all-guides.com
all-guides.com

AQS-HSN1-C
Advanced Microwave Products
PO Box 1437
2465 Old Highway 40 West, Suite 200
Verdi, NV 89439
How to Congure Your Amplier
The HSN1 power amplier does not require any conguring unless it includes optional variable
output level. If included, the power level is set via commands using the Comm port. See the HSN1
Interface Control Document (ICD) for more details.
SMA Female
RF Input
SMA Female
RF Output
Wiring Your HSN1 Power Amplier
MDM-9P
Power & Conguration
1:
2:
3:
4:
5:
6:
7:
8:
9:
+11 to 16 VDC Input
Ground
Ground
Ground
Enable (Open=On, Ground (or <1.5 Vdc)=O)
NC/Tx Comm-
Tx Comm+
Rx Comm+
NC/Rx Comm-
1 5
6 9
All manuals and user guides at all-guides.com