Andon iHealth User manual

iHealth Scale
QUICK START GUIDE

1 × iHealth Scale
4 × 1.5V AAA Batteries
1 × Quick Start Guide
26.6mm306mm
306mm
IN THE BOX
The iHealth Scale is a precision electronic instrument intended for adult
use. The Scale utilizes ITO biology and pressure sensors to measure
body composition components automatically. The measurements are
displayed and stored on iOS or Android device with date and time.
INTENDED USE

2
1
SETUP
App Store
Google Play
Install 4 AAA batteries into the compartment. Please note the
positive and negative sign.
Download the “iHealth MyVitals” app from the App Store
or the Google play. Follow the on-screen instructions to
register and set up your iHealth ID.

3
4
Add your device when prompted by the iHealth app. Please
make sure your phone's Bluetooth is enabled and the iHealth
Scale is nearby to establish connection.
After the connection is established, perform measurement by
standing on the scale with barefoot.

NOTE
TIPS
No wet feet Don't wear socks Don't keep your
knees together.
1. Place the iHealth Scale on a hard, at surface during use. Using the
scale on a soft surface like carpet or linoleum may impact the
accuracy of measurement.
2. Please make sure the information you entered in the iHealth app is
correct to get the most accurate results.
3. The primary user who installed the device can share it with your
family members.
4. If the iHealth Scale is shared by users with similar weights, make
sure that the phone's Bluetooth is enabled and the scale is nearby. If
the scale is not connected to the iHealth app, data may not be
recorded accurately.
5. The primary user can set the "Connected Measurement Only" and
"Weight-Only" in the iHealth app.
6. iHealth Scale is intended for daily family use and not considered as a
medical device.
7. The following should use the iHealth Scale only as reference as the
body fat rate will be dierent from the average measurement:
People who are under 18 years of age, over 65 years old, pregnant
women, patients with osteoporosis or very low bone density,
patients with edema, or articial dialysis.

LED DISPLAY
Abnormal electrical impedance
measurement.
Connection error with weight
measurement module.
Weight not in supported range.
Unstable measurement.
Flash access error.
Firmware update error.
Connection error with app.
The battery is low, please replace
with new battery as soon as
possible.
The battery is running out, please
replace with new battery.

Never use this product in combination with medical electronic devices
such as:
(1) Medical electronic implants such as pacemakers.
(2) Electronic life support systems such as articial heart/lungs.
(3) Portable electronic medical devices such as electrocardiographs.
This product could cause these devices to malfunction posing a
considerable health risk to users of these devices.
1. Product name: iHealth Scale
2. Model: HS2S
3. Product Size: 306×306×26.6mm
4. Product weight: 1.84kg
5. Classication: internally powered, type BF applied part (four
electrodes)
6. Power: 4×1.5V AAA batteries
Battery life: approx. 3 months with daily usage
7. Display units: Ib/kg
8. Compatibility: Android 5.0+, iOS 9.0+
9. Measurement range:
Body Weight: 11 lb-400 lb/5 kg-180 kg
Body Fat: 5.0%-65.0%
Scale resolution:0.lb/0.1kg
10. Accuracy:
Body Weight: ±1.1 lb/0.5 kg(11-110 lb / 5 kg-50 kg);
±1% (110-400 lb / 50 kg-180 kg)
Body Fat: ±1%
11. Operating temperature: 41°F-104°F (5°C - 40°C)
12. Operating humidity: 20 - 85%RH
13. Storage and transport temperature: -4°F-131°F (-20°C - 55°C)
14. Storage and transport humidity: ≤90%RH
SPECIFICATIONS
CONTRAINDICATION

Never use this product in combination with medical electronic devices
such as:
(1) Medical electronic implants such as pacemakers.
(2) Electronic life support systems such as articial heart/lungs.
(3) Portable electronic medical devices such as electrocardiographs.
This product could cause these devices to malfunction posing a
considerable health risk to users of these devices.
1. Do not stand on the edge of Scale, as you may fall over or inuence
the accuracy of the measurement.
2. Do not use the Scale on a tiled or wet oor, as this may result in a fall.
3. Make sure the surface of the Scale is clean and dry before you step
onto it, to prevent any slippage.
4. Treat your Scale with care. Do not drop it or jump on it. The Scale is
designed to be stood on; misuse or abuse may break the electronic
sensors, cause injury, or result in inaccurate measurements.
5. Avoid using this Scale near strong magnetic elds, such as
microwave ovens, etc.
6. This device complies with part 15 of the FCC Rules. Its operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
7. Changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
GENERAL SAFETY & PRECAUTIONS
Pregnant women need to consult their healthcare provider before use.
Some physical conditions could aect hydration levels that may lead to
inaccurate results. Please consult your healthcare provider for more
information.

reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment to an outlet on a circuit dierent from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
8. This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions: (1)This device may not cause interference.(2)This
device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1)L’appareil ne doit pas produire de
brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
9. This equipment complies with IC RSS‐102 radiation exposure limits
set forth for an uncontrolled environment. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
Cet équipement est conforme aux limites d'exposition aux radiations
IC CNR‐102 établies pour un environnement non contrôlé. Cet
émetteur ne doit pas être situé au même endroit ou fonctionner
avec une autre antenne ou un autre émetteur.
10. Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain

The iHealth scale is warranted to be free from defects in materials and
workmanship appearing within 1 year from the date of purchase, when
used in accordance with the instructions provided. The above
warranties extend only to the original retail purchaser. We will, at our
option, repair or replace without charge any product covered by the
above warranties. Repair or replacement is our only responsibility and
your only remedy under the above warranties.
1. Avoid high temperatures and irradiation.
2. If the Scale is stored close to freezing point, allow it to acclimate to
room temperature before use.
3. Remove the batteries if the Scale is not going to be used for 3
months or more.
4. Clean the Scale with a soft damp cloth. Do not use abrasive or
solvent-based cleaners, and never immerse it in water.
5. The Scale will maintain its safety and performance features for at
least 10,000 measurements or two years of use.
CARE & MAINTENANCE
WARRANTY INFORMATION
should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful
communication.
11. Bluetooth® associated logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by iHealth Labs, Inc.is
permitted under license.
Other trademarks and trade names are those of their respective
owners.

Please recycle where facilities exist. Waste electrical
products should not be disposed of with household
waste. Check with your local authority or retailer for
recycling advice
Keep dry
Refer to the User Manual
Warning
EXPLANATION OF SYMBOLS ON UNIT
Manufacturer
Hereby, [iHealth Labs, Inc.], declares that this [HS2S] is
in compliance with the essential requirements and
other relevant provisions of RED 2014/53/EU.RED
2014/53/EU declaration of conformity can be
downloaded on the following link :
https://www.ihealthlabs.eu/support/ certications

USA:
iHealth Labs, Inc. www.ihealthlabs.com
120 San Lucar Ct., Sunnyvale, CA 94086, USA
ANDON HEALTH CO., LTD.
No. 3 Jin Ping Street, Ya An Road, Nankai District, Tianjin
300190, China. Phone number: +86-22-87611660
Europe:
iHealthLabs Europe SAS www.ihealthlabs.eu
36 Rue de Ponthieu, 75008, Paris, France
Customer service: https://ihealthlabs.eu/en/assitance
HS2S-QSG-EN-20190426-V1.0
Table of contents