AndyMark Linear Servo User manual

1
www.andymark.com
Linear Servo
Shifter
Assembly/Mount
Guide
for

2
www.andymark.com
Step 1: Attach the Slide Block to the
Servo Bracket using two 10-32 Phillips
Head Screws.
Step 2: Screw the Encoder into place.
Step 3: Slide the Servo through the
servo slot on the Bracket.
Step 4: Attach and tighten four sets of
8-32 Screws with their respective Nylon
Nuts to set the Servo in place.
Step 5: Attach and screw on the 12
Tooth Servo Gear onto the Servo.
Linear Servo Assembly/Mount

3
www.andymark.com
Step 6: Rotate the servo counter-
clockwise until it reaches the end of its
path.
Step 7: Slide and push the Slide Rack
onto the Slide Block, rotating the gear
while pushing into position.
Step 8: Place the washer on Shoulder
Screw and screw into Slide Block through
the Slide Rack.
Step 9: Slide the ¼”-28 Screw through
the Slide Rack and place the Rubber O-
Ring on the other side.

4
www.andymark.com
Step 10: Line the Servo Shifter holes up
to the Motor Plate and attach using two
10-32 Phillips Head Screws.
Step 11: Screw the ¼”-28 Screw with the
Rubber O-Ring into the Shifter block.