AndyMark 57 Sport User manual

1
57 Sport
Motor Installation Guide

2
Step 5: Be sure to add a pea-sized amount of
included Red Tacky Grease (am-2768) to the gear
teeth. If more than one stage is present in the
gearbox, add grease to each stage.
Step 1 : Carefully press the pinion provided
with the 57 Sport gearbox onto the RedLine,
700 or 500 series motor. Be sure to leave a small
(~1/32" or 1mm) gap between the pinion and
the output shaft bushing.
Step 4: Attach the Motor Input Block to the
RedLine, 700 or 500 series motor (with previously
attached pinion) using the included M4-0.7 Socket
Head Screws and M4 Lock Washers. Be sure to
install the Motor Input Block with the non-circular
side against the motor.
Step 3: Remove the Motor Input Block and the
steel Thrust Washer. Set the Thrust Washer
aside on a clean shop towel or paper towel.
Step 6: Reinstall the Thrust Washer into the 57
Sport onto the surface of the gears inside the
gearbox. Insert the Motor Assembly into the
gearbox, and gently turn the output shaft until the
gears mesh.
Step 2: Remove the two 10-32 x 1.75 in. Socket
Head Screws from the 57 Sport.
Motor Input
Thrust Washer
1/32" or 1mm gap

3
Step 7: Once the gearbox is put together, reinstall
the 10-32 x 1.750 Socket Head to secure the Motor
Assembly.