Step 3. Connect Computer to Your Anker Device Wirelessly
Step 4. Configure the Device
From your computer, view your available wireless connections (typically
accessible from the corner of your desktop).
Choose the newly available "Anker-Repeater" network and connect to it. Note
that no password is needed at this time. Please do not enter any passwords or
PIN codes if prompted, and proceed to connect anyway.
3.1
3.2
2.3
Click Setup Wizard in the navigation bar on the left.
Select Wireless Universal Repeater Mode and click Next.
Click Site Survey and identify the existing wireless network of your router or
modem from the list of available networks. Select it, record the setting listed under
the Encrypt field and click Next. Please ensure that the signal strength is above
80%
You will be asked to configure the wireless client manually. Please select the same
Wireless Client Security Options as your existing router (recorded in step c) and
input its PassPhrase i.e. password to logon it. Click Next.
Keep Synchronize Wireless Universal Repeater's And Uplink AP's SSID And
Security Options unchecked.
Note: We do NOT recommend this setting, since it enables the wireless roaming
function. For further explanation, please refer to FAQ Question 3.
Customize the SSID, i.e. the name of your new wireless network. The default
a.
b.
c.
d.
e.
4.1 Logon to the device's configuration page
Open a web browser on your computer, and type 192.168.100.253 to reach the
device's configuration page. When the log-on dialogue is displayed, enter your default
UserName/Password: admin/admin to logon to the Anker device's configuration web
page.
4.2 Configure the device
that your desired location has a stable Wi-Fi signal from your original router.
Note: > 80% signal strength is ideal. You can see the single strength in Step 4.2c.
Plug the Anker device into the wall socket; the LED indicators will light after 15
seconds. Please allow a 2-minute start up time.
4
