Anritsu 2000-2074-R User manual

Quick Start Guide
Extended Power Pack
2000-2074-R
Caution
Do not adjust the DC output voltage when the DC cable is
connected to the instrument. Set the output to 16 VDC before
making any connections. Damage to the instrument’s internal
circuitry may result if incorrect DC power is applied.
Anritsu Company
490 Jarvis Drive
Morgan Hill, CA 95037-2809
USA
http://www.anritsu.com
Part Number: 10580-00494
Revision: A
Published: November 2022
Copyright 2022 Anritsu Company, USA. All Rights Reserved.

QSG-2 PN: 10580-00494 Rev. A 2000-2074-R QSG
Overview
The extended power pack front panel and contents are shown below. To
charge the instrument connect the instrument with extended power pack
using DC-DC barrel connector cable. USB Type A and Type C ports can be
used to recharge the extended power pack using an AC-DC USB adapter.
1. Powered Button/Voltage Selector
2. Battery and Voltage Indicator
3. DC In/Out Port
4. USB A Ports (2) (Do not connect to instrument USB ports)
5. USB C Port (Do not connect to instrument USB port)
6. USB C Cable to Charging Source
7. DC-DC Barrel Connector Cable to Instrument (Adjust voltage before
connecting to instrument as described in the next section.)
1 3 42 5
6
To Instrument
To USB Charger
7

2000-2074-R QSG PN: 10580-00494 Rev. A QSG-3
Setting the Voltage
The rechargeable battery bank provides DC power to the instrument. Set the
voltage to 16 VDC BEFORE making any connections to the instrument.
To set to 16 VDC:
1. Press and hold the power button for two seconds and release. Each of
the four voltage indicator LEDs sequence through during power on. If
the four LEDs do not light, the battery is not fully charged and will
need to be charged before continuing.
2. Set to DC output mode by double-pressing the power button.
3. In DC output mode, set to 16 VDC by single-pressing the power button
to sequence through each voltage setting.
4. Set to the 16 VDC position as shown below. The voltage output is now
set to 16 VDC and the power pack can be safely connected to the
instruments DC power input jack.
Caution
Do not adjust the DC output voltage when the DC cable is
connected to the instrument. Set the output to 16 VDC before
making any connections. Damage to the instrument’s internal
circuitry may result if incorrect DC power is applied.
16 VDC
12 V 16 V 19 V 24 V

Anritsu Company
490 Jarvis Drive
Morgan Hill, CA 95037-2809
USA
http://www.anritsu.com
Anritsu utilizes recycled paper and environmentally conscious
inks and toner.