Zido Single Monitor Mount Assembly Instructions 3
STEP 1
Attach the VESA plate to your monitor
Place the VESA bracket in position on the back of the monitor. Attach using four
M4 x 12MM Screws (part #M-A) provided in the plastic bag. The VESA bracket
accommodates 75mm and 100mm hole patterns. For this installation, you may also
use the screws that came with your monitor.
STEP 2
Assemble the Brackets
Align the Tilt/Pan Mount with the 2 outer holes that are directly above and below
the 6 small holes in the center of the outer bracket. Secure using 2 M6 x 12mm
Button-head Screws using the 5/32" hex key. (A)
Slide the inner bracket into the outer bracket so that the holes on each side align.
Using the 5/32” hex key, secure with 4 1/4-20 x 1/2" Button-head Screws. (B)
STEP 3
Install the Brackets and the Monitor
Slip the bracket assembly over the top of the Zido tube, with the assembly facing
the front of the cart. Be sure the assembly is installed right side up, with the curved
slot being at the top of the assembly (A). Secure with 2 self-threading screws. (B).
Note: These fasteners are creating the threads in the tube, so the first few turns will require some force.
Lift the monitor into place in front of the Tilt/Pan Mount. Slide the VESA bracket
into the curved slot in the Tilt/Pan Mount.
Secure the monitor to the Tilt/Pan Mount using 2 Security Allen Screws (part #
P-C) using the Allen Wrench (part #P-E), making sure to place a washer (part #P-D)
between the screw and the VESA plate.
To adjust the position of the monitor, loosen the knob on the side of the Tilt/Pan
Mount to adjust and tighten again when the monitor is in the desired position.
CONGRATULATIONS!
YOUR ZIDO SINGLE MONITOR MOUNT ASSEMBLY IS COMPLETE!
Self-threading Screw
325-5464-00
A.
B.
Top of assembly
Curved Slot
Knob
Knob
A.
B.
Self-threading
Screws
Outer Hole
M6 x 12MM Screws
1/4-20 X 1/2"
Button-head Screws
1/4-20 x1/2” Button-hd Screw
2
-
-
M6 x 12mm Button-hd Screw
325-5757-00
