AOpen XC Cube User manual

Easy Installation Guide
To learn more aboutAOpen XC Cube, visit us at http://xc.aopen.com.tw, http://www.aopen.com
P/N:49.MZ102.0A2 Doc.No:MZ855-II_915-M-EG-E0509B
MZ855-II / MZ915-MMZ855-II / MZ915-MMZ855-II / MZ915-M
MZ855-II Series MZ915-M Series
Plug the RJ45 cable into the
network jack (recognizable
by an icon with three tiny
computers). [ Depending on
models. ]
124 3
56
Connect the purplekeyboard
connect or to thematching purple
connect or at therear panel. Also
connect the greenmouse
connect or tothegreen connector
at the rear panel.
Connect the speakers' audio cable
to the light green speaker jack at the
rear panel. Also insert the speakers'
power plug into a properly grounded
AC wall socket. [ Depending on
models. ]
Connect the microphone cable
to the pink microphone jack at
the rear panel. [ Depending on
models. ]
Depending on the type of
printer that you have,connect
the printer's data cable to the
blue-colored parallel port as
shown in the picture.
87Connect the other end of the
power cord to the AC wall
socket, and press the power
button to boot up your system.
Connect the power cord to
the system's power connector
as shown.
Connect the monitor's video
cable to the blue monitor
connect or located at the
rear panel.
4-pin ATX Power
AGP 4X
PCI slot
Front Audio
IDE Connector x 2
(ATA33/ 66/100)
JP14 CMOS Jumper
Front Panel
Connector
AC'97 CODEC
CD_IN
AUX_IN
JP4 & JP5
AUX_IN Jumper
USB 2.0 x 4
DDR333/266/200
DIMMx 2
Max. 2 GB
ATX Power
IEEE 1394 x 2
JP28 KB/MS
Wake_up Jumper
Back Panel
CPUFAN1
Printer Connector
FDD Connector
479-pin CPU Socket
supports Intel®
Pentium® M and
Celeron® M CPU
Intel 855GME +
ICH4-M Chipset
FSB 533 Enable Jumper
Switch to pin 1 & 2 for 400MHz*
Switch to pin 2 & 3 for 533MHz
*default
4-pin ATX Power
IDE Connector x 1
(ATA33/ 66/100)
Serial ATA X 4
USB 2.0 x 4
EPS ATX Power
IEEE 1394 x 2
JP28 KB/MS
Wake_up Jumper
Back Panel
Printer Connector
7.1 Channel CODEC
Front Audio
CD_IN
PCI slot
PCI express X 16
FDD Connector
479-pin CPU Socket
supports Intel®
Pentium® M and
Celeron® M CPU
Intel 915G +
ICH6 Chipset
DDR2 400/533
Max. 2 GB
SYSFAN
CPUFAN1
Front Panel
Connector
USB 2.0
TV OUT (S-Video)
Y/Pb/Pr Composite
SPDIF OUT
COAXIAL OUT
D4 OUT
Cooler Installation Technical Notice
1
Push four iron plates up a bit
and then put CPU cooler firmly
onto the CPU retention module.
Note: For Optimized
heat-dissipating, the fan should
be placed next to the slots
onboard.
* MZ855-II and MZ915-M are designed
for LVDS ( low voltage differential signal
interface ), there will be the possibility
that the monitor won't work properly
after powering on. If this condition
happens, please press < Ctrl + Alt + F1 >
concurrently to enable the monitor.
2
Press four iron plates
downward till you hear a "chip"
sound.
3
Connect the fan cable onto the
CPU FAN connector onboard.
Socket 479 CPU Frequency Table
Vender Processor FSB Multiplier
Intel Pentium M 770 ( 2.13 GHz-Dothan ) 533 MHz 16 x
Intel Pentium M 760 ( 2.00 GHz-Dothan ) 533 MHz 15 x
Intel Pentium M 750 ( 1.86 GHz-Dothan ) 533 MHz 14 x
Intel Pentium M 740 ( 1.73 GHz-Dothan ) 533 MHz 13 x
Intel Pentium M 730 ( 1.60 GHz-Dothan ) 533 MHz 12 x
Note: With CPU changing rapidly, there might be fastest CPU on the
market by the you received this installation guide. This table is kindly for
your references only.
MZ915-M Series
Power Button
Optical Device
/ Slim Device Bay
HDD Indicator
IEEE1394 Port
(6 pin)
IEEE1394 Port (4 pin)
S/PDIF OUT Port
Earphone Jack
Microphone Jack
USB 2.0 Ports
S/PDIF IN Port
Ethernet Network
Connector (RJ45)
USB 2.0 Ports
Coaxial Out RCA Port
IEEE1394 Port
(6 pin)
Line-In Jack (SUR)
Line-Out Jack (L/R)
Microphone
Jack (C/B)
Line-In Jack
SPDIF-IN
Line-Out Jack (L/R)
Microphone
Jack
COM1 Port
Monitor Connector
PS/2 Mouse Connector
PS/2 Keyboard Connector
IEEE1394 Port
(6 pin)
USB 2.0 Ports
Ethernet Network
Connector (RJ45)
SIDE L/R
TV OUT
Y/Pb/Pr
S-Video
Composite
D4 TV-Out
(Optional)
Center/Sub-woofer
Surround L/R
MZ855-II MZ915-M
Intel Pentium M 770 ( 2.13 GHz-Dothan ) 533 MHz 16 x
Intel Pentium M 760 ( 2.00 GHz-Dothan ) 533 MHz 15 x
Intel Pentium M 750 ( 1.86 GHz-Dothan ) 533 MHz 14 x
Intel Pentium M 740 ( 1.73 GHz-Dothan ) 533 MHz 13 x
Intel Pentium M 730 ( 1.60 GHz-Dothan ) 533 MHz 12 x
Intel Pentium M 755 ( 2.0 GHz-Dothan ) 400 MHz 20 x
Intel Pentium M 745 ( 1.8 GHz-Dothan ) 400 MHz 18 x
Intel Pentium M 735 ( 1.7GHz-Dothan ) 400 MHz 17 x
Intel Pentium M 725 ( 1.6GHz-Dothan ) 400 MHz 16 x
Intel Pentium M 715 ( 1.5GHz-Dothan ) 400 MHz 15 x
Intel Pentium M 1.7GHz ( Banias ) 400 MHz 17 x
Intel Pentium M 1.5GHz ( Banias ) 400 MHz 15 x
Intel Celeron M 360 ( 1.4GHz-Dothan ) 400 MHz 14 x
Intel Celeron M 350 ( 1.3GHz-Dothan ) 400 MHz 13 x
Intel Celeron M 340 ( 1.5GHz-Banias ) 400 MHz 15 x
MZ855-II Series
Socket 479 CPU Frequency Table
Note: With CPU changing rapidly, there might be fastest CPU on the
market by the you received this installation guide. This table is kindly for
your references only.
Vender Processor FSB Multiplier
If the user intends to use the HDTV video output from an add-on VGA card, s/he
needs to take out all the shorting caps of JP29, JP30. Please save the shorting
caps in a safe place in case the user intends to use the on-board HDTV
connector.
JP29 JP30
HDTV ON ON
PCIE CARD OFF OFF
The HDTV output interface connector on
the back panel of the system is enabled by
applying shorting caps to JP29, JP30 as
shown in the illustrtion.
HDTV Selection Jumper Setting
* MZ915-M already has built-in TV-out
functionality; therefore, it cannot support
a separate ADD2 (TV tuner) card in the
PCIe slot.
C
M
Y
CM
MY
CY
CMY
K
MZ855-II_915-M-EG-E0509B.pdf 2005/9/15 上午 11:01:04MZ855-II_915-M-EG-E0509B.pdf 2005/9/15 上午 11:01:04