Before you install the hob, make sure that
The work surface is square and level, and no structural members interfere
with space requirements
The work surface is made of a heat-resistant material
If the hob is installed above an oven, the oven has a built-in cooling fan
The installation will comply with all clearance requirements and applicable
standards and regulations
A suitable isolating switch providing full disconnection from the mains power
supply is incorporated inthe permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap
contact separationin all poles (or in all active [phase] conductors if thelocal
wiring rules allow for this variation of therequirements)
The isolating switch will be easily accessible to the customer with the hob
installed
You consult local building authorities and by-laws if in doubt regarding
installation
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for
the wall surfacesurrounding the hob.
When you have installed the hob, make sure that
The power supply cable is not accessible through cupboard doors or drawers
There is adequate flow of fresh air from outside the cabinetry to the base of
the hob
If the hob is installed above a drawer or cupboard space, a thermal
protection barrier is installed belowthe base of the hob
The isolating switch is easily accessible by the customer
•Th
euni tshoul db eplace do n astable ,smoot hsurfac e(us eth e
packaging) .D ono tappl yforc eont oth econtrol sprotrudin gfro mth ehob.