APG doc no. M-23G-510-06 Rev J 5 (7)
Declaration of onformity
F
Note:
This equi ment has been tested and found to com ly with the limits for a Class B digital device,
ursuant to art 15 of the FCC Rules. These limits are designed to rovide reasonable rotection
against harmful interference in a residential installation. This equi ment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a articular installation. If this equi ment does cause harmful
interference to radio or television rece tion, which can be determined by turning the equi ment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the se aration between the equi ment and receiver.
—Connect the equi ment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an ex erienced radio/TV technician for hel .
Changes or modifications not ex ressly a roved by the arty res onsible for com liance could
void the user's authority to o erate the equi ment.
RF Ex osure Guidance: This equi ment com lies with FCC radiation ex osure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or o erating in conjunction with
any other antenna or transmitter, exce t in accordance with FCC multi-transmitter roduct
rocedures.
Industry anada
This device com lies with Industry Canada licence-exem t RSS standard(s). O eration is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
acce t any interference, including interference that may cause undesired o eration of the device.
CAN ICES-3(B)/NMB-3(B)
Le résent a areil est conforme aux CNR d'Industrie Canada a licables aux a areils radio
exem ts de licence. L'ex loitation est autorisée aux deux conditions suivantes : (1) l'a areil ne
doit as roduire de brouillage, et (2) l'utilisateur de l'a areil doit acce ter tout brouillage
radioélectrique subi, même si le brouillage est susce tible d'en com romettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only o erate using an antenna of a
ty e and maximum (or lesser) gain a roved for the transmitter by Industry Canada. To reduce
otential radio interference to other users, the antenna ty e and its gain should be so chosen that
the equivalent isotro ically radiated ower (e.i.r. .) is not more than that necessary for successful
communication.
