Aqua Systems SmartChoice II Wi-Fi User manual

Quick Start Wi-Fi Setup
SmartChoice™II Wi-Fi
CLOCK REGEN NEXT
>
>

2.
Date of Installaon:
Serial Number:
MAC id:
Dealer Name:
Installer:
Important Product Information
(Aqua Systems’ Installer to complete this page)

3.
Wi-Fi Location
Getting the best signal strength
To get the best signal strength, please refer to the diagram below.*
*If you are unable to connect to your Wi-Fi, you might need to get a Wi-Fi
range extender to boost your exisng Wi-Fi signal.
Equipment Location
This Wi-Fi and Aqua
Systems equipment
locaon should provide
the signal strength
needed.

4.
Connecting to your SmartChoice™ II Wi-Fi:
Place your system valve in “Wi-Fi Seng” mode.
On the valve press the Clock and Down buons at the same
me and hold for 15 seconds.
CLOCK REGEN NEXT
>
>
Press Clock and down
buons together and hold
for 15 seconds
1

5.
Connecting to your SmartChoice™ II Wi-Fi:
Using a computer or mobile device, “Wi-Fi network manager”,
select the Wi-Fi network that matches your Aqua Systems
equipment MAC id. See your equipment documents for exact
name. (ie. B0xxxxxxxxxx).
(If you do not see your Aqua Systems equipment MAC id, go back
to step #1 to place your equipment in “Wi-Fi Seng” mode again.)
If this is the rst me that you are connecng, you will be asked for
a password of “12345678”
2

6.
Connecting to your SmartChoice™ II Wi-Fi:
Using the same computer or mobile device, open the the web
browser and enter the address: 192.168.0.1
Aer the page loads, select the Wi-Fi network that best suits
your Aqua Systems equipment.
If the network you are selecng is password protected, type in
the Wi-Fi network password and enter.
3
192.168.0.1

7.
Connecting to your SmartChoice™ II Wi-Fi:
To complete setup, visit hps://wi.ilovemywater.com and
register your Aqua Systems equipment.
4
ONLINE
REGISTRATION
SUBMIT

8.
Setup Summary
Place your system valve in “Wi-Fi Seng” mode.
On the valve press the Clock and down buons at the same me
and hold for 15 seconds.
Using a computer or mobile device, “Wi-Fi network manager”,
select the Wi-Fi network that matches your Aqua Systems
equipment MAC id. See your equipment documents for exact
name. (ie. B0xxxxxxxxxx).
(If you do not see your Aqua Systems equipment MAC id, go back to
step #1 to place your equipment in “Wi-Fi Seng” mode again.)
If this is the rst me that you are connecng, you will be asked for a
password of “12345678”
Using the same computer or mobile device, open the the web
browser and enter the address: 192.168.0.1
Aer the page loads, select the Wi-Fi network that best suits
your Aqua Systems equipment.
If the network you are selecng is password protected, type in
the Wi-Fi network password and enter.
To complete setup, visit hps://wi.ilovemywater.com and register
your Aqua Systems equipment.

9.
NOTES

10.
NOTES

11.
NOTES

© 2017 Aqua Systems