AquaMedix CleanSpray 1690 User manual

0501690-2.0
CleanSpray Faucet Filter Instructions
Disposable <0.2 µm Micro-Filters
1690 CleanSpray Faucet Filter (3 Month)
1630 CleanSpray Faucet Filter (1 Month)
48116 CleanSpray Compliance Connector + Adapter Kit
CleanSpray Faucet Filters are easy to install. The connector threads
are 55/64”-27 F for connection to most standard faucets. Included
is one 15/16”–27 M x 55/64”–27 Madapter and one extra flat
gasket seal. (Note: Other adapters may be required for non-
standard threads and are available through AquaMedix).
Read all instructions prior to installation to ensure effective & safe
operation of CleanSpray devices.
Turn off water supply and disinfect faucet prior to installation.
1. Wash hands thoroughly and apply gloves to avoid
contamination.
2. Remove existing aerator (end piece) from faucet if present.
3. If faucet end is male, 55/64”-27 skip to step 6.
4. If faucet end is not male 55/64”-27, an adapter will be required
to convert it to male 55/64”-27 before installing the
Compliance Connector.
5. Determine size of adapter required (kit QCK17 is available to
help determine appropriate thread adapters).
6. Screw the Compliance Connector onto faucet (or adapters) by
turning clockwise until secure. Ensure gasket seal is properly
positioned (DO NOT OVER TIGHTEN).
7. Slide CleanSpray faucet filter onto Compliance Connector until
it locks into place (see photo above).
8. Run hot water for 2 minutes to wet the filter before use.
Inspect for water leaks around fittings. If leaks occur, remove
and reattach connector (refer to step 6). If reattachment or
reinstallation is required disinfect the surface of connector and
filter before use.
Water flow and pressure may be slightly reduced due to the Micro-
Filter. Maximum operating water pressure 75 psi.
The outlet of the filter needs to be 1” or more above the top rim of
the sink. All seals must be secure. Assure no water leakage for
best bacterial control. Potable water service only.
DO NOT USE Pipe joint compound or other thread sealants.
Thread seal tape (PTFE tape/plumber's tape) may be used to
prevent leaks if necessary.
Filters are FDA Class I Medical Devices/EPA Pest Control Devices.
Replacing CleanSpray Faucet Filter:
AquaMedix Part #1630 (30 day) or #1690 (90 day)
Turn off water supply and disinfect tap faucet prior to
installation.
1. Wash hands thoroughly and wear gloves to avoid
contamination.
2. Press in white connector clip with finger or thumb.
3. Maintain pressure on white connector clip while
simultaneously pulling off used faucet filter until faucet filter
releases.
4. Unpackage replacement faucet filter and slide it onto the
connector until it locks into place.
5. After installation, run water for 2 minutes through the filter
to wet the filter before use. If leaks are present around
fittings, remove and reattach the connector (refer to step 6
of installation instructions). If reattachment or reinstallation
is required, disinfect the surface of connector and filter
before reinstallation.
Exhausted filters can be disposed of in normal trash.
All seals must be secure. Assure no water leakage for best bacterial
control.
CleanSpray Faucet Filters have been tested and meet the
requirements of ASTM F838-05, for micro filtration. Filters
effectively demonstrated a >99.99999% of (>log 7) reduction of
bacteria in the water flowing through the filters.
Operation: The Micro-Filter should be replaced when water flow
decreases below acceptable levels. The Micro-Filter will continue
to remove and capture contaminants in water so long as the
water is flowing. Maximum filter life varies based on model
(1 month or 3 months). Water systems with high concentration
of particulates limit useful filter life. A documented Micro-Filter
replacement & maintenance schedule must be established after
the device is installed. CleanSpray products must be installed and
used in accordance with state and local regulations.
Warning: CleanSpray products are intended for use with
potable water service only in accordance with the Safe Water
Drinking Act. These products are not intended to be used for
contaminated water, untreated surface water, wastewater or
water contaminated by human or animal sewage. The Micro-
Filter will not remove pathogenic viruses in water. Do not
attempt to clean Micro-Filter or to use damaged cartridges or
Micro-Filters. Use only within product specifications and
guidelines.
AquaMedix, LLC | 7169 Shady Oak Rd. | Eden Prairie, MN 55344
www.aquamedix.net │ [email protected] │952-479-0636
Made in USA │ US Patent No. D823433 │ EPA Est. No. 89767-MN-001

0501690-2.0
AQUAMEDIX, LLC
CleanSpray®
Limited Warranty
AquaMedix, LLC (“AquaMedix”) warrants that for a period of two years from the original date of purchase or up to the expiration date
listed on the product or on the product packaging, this product will be free from defects in materials and workmanship.
AquaMedix, at its option, will repair or replace the product or any component of the product found to be defective during the warranty
period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available,
replacement may be made with a similar product of equal or greater value. This is your exclusive warranty.
This warranty is valid for the original purchaser from the date of original purchase and is not transferable. Keep the original sales
receipt. Proof of purchase is required to obtain warranty service. AquaMedix resellers do not have the right to alter, modify or change
the terms and conditions of this warranty in any manner.
This warranty does not cover normal wear of components or damage resulting from any of the following: negligent use or misuse of the
product, use contrary to the installation, use and care guide, repair or alteration by anyone other than AquaMedix or an authorized service
center. Further, the warranty does not cover acts of nature, such as fire, flood, tornadoes or hurricane.
AquaMedix shall not be liable for any incidental or consequential damages caused by the breach of any express or implied warranty.
Except to the extent prohibited by applicable law, any implied warranty or merchantability or fitness for a particular purpose is limited
in duration to the duration of the above warranty. Some states, provinces or jurisdictions do not allow the exclusion or limitation of the
incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusions may
not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state or
province to province.
How to Obtain Warranty Service
Call us at [phone] or send email to [e-mail]. If it is determined that it is necessary to return the product, a Return
Authorization Number will be issued. Products returned without a Return Authorization Number will be refused. Pack the
product in the original carton, or equivalent, using newspaper or other packing materials to protect the product from damage in transit.
Before sealing the carton, be sure to include a copy of the original sales receipt along with a note describing the nature of the defect or
problem. Be certain to include your return shipping address and the Return Authorization Number on the outside of the carton.
Ship the product postage paid to:
AquaMedix, LLC
7169 Shady Oak Road
Eden Prairie, MN 55344
Upon receiving the product, we will repair or replace the product and return it to the return address on the shipping carton, postage pre-
paid.
V022720-1.0