Aquapure AOT-FD-500 User manual

OZONE MODULE
Model : AOT-FD-500
Thank you for purchasing our product! This operation manual contains
specification, performance curve, Safety, Attention, FAQ, Maintenance
etc. To ensure your efficient use of the module, please read this
operation manual carefully before operating.
Specification :
Model No
AOT-FD-500
Ozone Output
500 mg/h at 2.5L/min dry air (20-25
℃
,<20% R.H)
Input Voltage
12V DC
Rated Power
< 12W
Generating Method
Corona discharge
Mechanical Part
304 S.S electrode and quartz tube
Size
139 x 78.4 x 35 mm
Weight
0.5kg/pc
Performance curve:
Safety:
A. This unit generates very high voltages. Do not dismantle or touch it unless the power supply is
disconnected;
B. Any servicing or maintenance should only be carried out by approved and qualified personnel;
C. All installations should only be carried out by qualified electricians.
1

Attention:
1. There are 3 types gases can be used for ozone generation: Ambient air, dry air and oxyge;
2. When use this unit, you should have power adaptor , air pump or venturi,silicone tube, check
valve,ect;
3. Ozone module introduction:
4. Air pump system: for air /water treatment
Air pump for water treatment system, bubble diffusers(similar to a fish tank air stone) are a popular ,
inexpensive method to inject ozone into water, the ozone gas transfer area occurs immediately at
the interface between the ozone bubble surface and the surrounding water. As the ozone bubble
risesm the gas at the bubble edge will transfer into the water. Using a diffuser requires enough
pressure to overcome the height of the water and any restrication in the diffusers due to hole size.
Drawing below:
2

5. Venturi system: for water treatment
A more popular method for delivering ozone is through the use of venturi injectors. Venturi
injectors work by forcing water through a conical body. This action creats a pressure differential
between the inlet and outlet ports,which results in a vacuum inside the injector body. This vacuum
causes rapid ozone suction through the suction part.Essentially, ozone gas is dissolved into the
wate r.
Drawing below:
FAQ:
No ozone comes out when power on?
A. Swift of the power, check if the
connection of each part is in good
condition or not;
B. Check if gas feed normal or not;
C. Check if the Electronics part of the ozone
module is broken or not.
Ozone leakage?
A. Check the tube exhaust gas normal or not;
B. Check the tube connection well nor not;
C. Check if the quartz tube of the ozone
generator module is broken or not.
Maintenance service:
This ozone module is warranted to be free from all defects in material in normal use for a period of (1)
year from date of purchase. Any damages or malfunctions caused by negligence, abuse, or not operate
in accordance with the User’s Manual are not covered by this warranty. Also, any defects or damages
caused by unauthorized service is not covered.
3