Aquatop Breza User manual

For more information on tank health and maintenance
as well as other products carried by Aquatop,
visit our website: www.aquatop.com
775 Columbia St. Brea, CA 92821
Tel: [phone] [phone]
www.aquatop.com
VI /2017
Products are warrantied by AQUATOP Aquatic Supplies to the original purchaser
against defective material and workmanship under normal use for a period of 1 year
from the date of the original purchase.
Products have no warranty if:
1.) The product has been serviced, modied or tampered with by anyone other than
AQUATOP Aquatic Supplies,
2.) The product has been abused or damaged (including broken or cracked bulbs),
and/or
3.) The product has been transported without proper packaging.
WARRANTY LIABILITY DISCLAIMER
In no event will Aquatop® be liable for any consequential or incidental damages,
including but not limited to, lost sea life, personal injury, property damage, equipment
damage, lost prots, lost wages, lost savings, lost income, etc., arising out of the use of
any Aquatop® product.
AQUATOP 1 YEAR LIMITED WARRANTY
OWNER’S MANUAL
aquatop.com
Battery Powered Aquarium Air Pump
Power Failure
Sensor
Cord
1
1
YEAR
WARRANTY
BREZA Battery Aquarium Air Pump Manual 2017

INTRODUCTION
CAUTION/SAFETY INFORMATION
1 2
Aquatop’s BREZA Battery Powered Air Pump is an essential piece of equipment for aquarists
of all levels. Although similar to standard aquarium air pumps, the BREZA AC/DC-ONE oers
an ingenious design which combines an AC power failure sensor with integral back-up battery
power! In the unfortunate event of a power outage or when the standard electrical connection
is lost, our battery powered air pump automatically switches over to back-up battery power
when the AC power failure sensor is plugged in, providing a temporary lift support system for
your aquatic creatures. The BREZA AC/DC-ONE’s versatile design also makes it a portable air
pump, perfect for sh bait buckets or for transporting aquatic creatures. The BREZA Battery
Powered Air Pump will help keep your sh alive and healthy each day, and will protect your
aquarium’s inhabitants during a power outage, even if you’re not around to turn it on.
1) Read and follow all instructions.
2) A drip loop must be used when plugging all electrical aquarium
devices. A drip loop is the part of the cord hanging
below the receptacle. (See Fig. 1)
3) A GFCI (Ground fault circuit interrupter) should be used in the branch circuit supplying all
power to air pumps and electrical aquarium equipment. If you do not have a GFCI,
we strongly recommend having a qualied electrician install one prior to operating any
aquarium component.
4) Do not plug into extension cord/power strip.
5) Use this product for its intended use only.
6) Never yank or pull the cord from the electrical outlet.
7) Do not operate if the plug or wire is damaged.
8) Do not operate without water.
9) Verify that hands are dry prior to disconnecting the power.
10) To reduce the risks of electrocution, keep all connections dry.
11) If the product falls into water, do not reach for it. First, unplug the unit. Then retrieve the
unit from the water. If any of the electrical components get wet, unplug immediately.
12) Do not use soaps or detergents when cleaning this device. Thoroughly clean and rinse
with warm water and make sure the device is completely dry before connecting.
13) For indoor use only.
• 1 x Unit
• Air Line Tubing - 20"
• Single Air Stone
WHAT'S INCLUDED
MODEL OUTPUT OUTLET POWER VOLT/FREG BATTERY
SIZE
AC/DC - ONE 2.5 L/M SINGLE 0.3 W 110 - 120V
60Hz
2 x D
Power Failure
Sensor cord
INSTALLATION
SPECIFICATIONS
NOTE: AQUATOP RECOMMENDS
INSTALLING THE UNIT ABOVE
THE AQUARIUM'S WATER LINE.
NOTE: Uses 2 x D cell batteries
( Not Included )
1. Open the cover of the Battery Power Air Pump and install 2 D Battery.
2. Attach the included airline to the Battery Power Air Pump.
3. Attach the included air-stone to the free and of the airline.
4. Secure the Air-Stone beneath the Aquarium's water line
5. Turn the power switch to the "ON" position
6. For emergency battery back-up power, plug the included power failure sensor
cord into an electrical outlet. The air pump will turn o.
7. In the event of a power outage or when the standard electrical connection is lost,
the air pump will automatically power on using battery power only.