
• Highly Efcient Design
• Ultra Quiet
• External Controller for Adjustable Flow Control
• 10 min Feeding Suspension
• In-line or Fully Submersed
• UL Power Supply & Cord
• For Fresh & Saltwater
The AQUATOP MAXFLOW Series of fully submersible pumps are powerful, yet quiet, and
designed for very low energy consumption. Capable of moving 515 to 2,377 gallons per hour,
the MAXFLOW Series is suitable for both fresh and saltwater aquarium use and is an excellent
choice for aquariums or sumps. These versatile pumps come equipped with an External Con-
troller for precise ow control and come equipped with numerous multi-purpose ttings for
in-line or fully submersible applications, and are easily installed as a main system pump in wet
and dry lters or sump boxes.
1 2
SPECIFICATIONS
SETUP / PARTS LIST
FEATURES:
INTRODUCTION
READ ALL SAFETY INSTRUCTIONS BEFORE USE
10. For indoor use only.
11. If any of the electrical components get wet, unplug immediately.
12. Do not use soaps or detergents when cleaning the exterior surface of this device.
13. Make sure the device is completely dry before connecting.
14. Keep this product away from children
WARNING
To guard against injury, basic safety precautions should be observed, including the following:
DANGER
To avoid possible electric shock, special care should be taken since water is employed around
the use of this product. For each of the following situations, do not attempt to repair yourself:
return the appliance to an authorized service facility for service or discard the appliance.
NOTE: It is your sole responsibility to verify that the plug and the receptacle are clean and
free of moisture and salt buildup at all times. The receptacle must be free of water,
salt, calcium, magnesium and dust. Failure to do so can cause re, damage to
property, and permanent damage to the product and personal injury not limited to
loss of life.
NOTE: Before installing the unit, check for any signs of damage to the device. If there are any
signs of damage to the device, power cable or plug, do not use and return to place of
original purchase.
1. Read and follow all instructions.
2. A drip loop must be used with all electrical aquarium devices.
A drip loop is a self-made part of the cord hanging below the
receptacle. (See g. 1)
3. A GFCI (Ground Fault Circuit Interrupter) should be used in the branch circuit supplying
all power to water pumps and electrical aquarium equipment. If you do not have a GFCI,
we strongly recommend having a qualied electrician install one prior to operating any
aquarium component.
4. Do not plug into extension cord/power strip.
5. Use this product for its intended purpose only.
6. Never yank or pull the cord from the electrical outlet.
7. Do not operate if the plug or wire is damaged.
8. Verify that hands are dry prior to disconnecting the power.
9. To reduce the risks of electrocution, keep all connections dry.
SAFETY INSTRUCTIONS (CONT’D)
MODEL FLOW MAX HEAD
HEIGHT
OUTPUT VOLT/FREQ AMP
MWP-500 515GPH 8’ DC24V 100V/60Hz 1.0A
MWP-1000 1110GPH 10.5’ DC24V 100V/60Hz 1.5A
MWP-1500 1479GPH 15’ DC24V 100V-60Hz 2.5A
MWP-2300 2377GPH 26’ DC24V 100V-60Hz 5A
IN WATER IN LINE
External Controller for
Adjustable Flow Control
Outlet
Inlet Strainer
Impeller Cap
Pump Base
Impeller
Pump Motor
O-ring
Nut
for MWP-2300
for MWP-500
MWP-1000
MWP-1500
PARTS LIST