
WARNING & SAFETY INFORMATION
The AQUATOP MAXFLOW Series of fully submersible pumps are powerful,yet quiet, and
designed for very low energy consumption. Capable of moving 95 to 1056 gallons per
hour, the MAXFLOW Series is suitable for both fresh and saltwater aquarium use and is
an excellent choice for water gardens or ponds. These versatile pumps offer ow control
and come equipped with numerous multi-purpose ttings for use as a power head or
circulation pump, and are easily installed as a main system pump in wet and dry lters or
sump boxes.
Before installing the MAXFLOW series, read and follow these important warnings
and safety information.
Note: When cleaning the pumps do not use soap or detergents. When cleaning the
impeller, do not use an abrasive instrument or cleaning device.
Note: Before cleaning or performing any maintenance, unplug from power source.
1) Remove the pump from the system.
2) Remove plastic lter cage from the front of submerged pump and remove
debris. Rinse with clean, fresh water.
3) Wash out the impeller housing with clean, fresh water.
4) Remove the impeller and the magnet. Inspect them for damage and wash
with clean, fresh water.
5) Wash out the impeller housing with clean, fresh water.
6) Reassemble the pump and re-install it in your system.
It is your sole responsibility to verify that the plug And the receptacle are clean and
free of moisture And salt build up at all times. The receptacle must be Free of water,
salt, calcium, magnesium and dust. Failure to do so can cause re, damage to property,
And permanent damage to the product and personal In. Jury not limited to loss of life.
1) Read and follow all instructions.
2) A drip loop must be used with all Electrical aquarium devices. A drip loop Is a
self-made part of the cord hanging below the receptacle. (See g. 1)
3) a GFCI (ground fault circuit interrupter) should be used In the branch circuit
supplying all power to water pumps. And electrical aquarium equipment. If you
do not have a GFCI, we strongly recommend having a qualied Electrician
install one prior to operating any aquarium Component.
4) Do not plug into extension cord/power strip.
5) Use this product for its intended use only.
6) Never yank or pull the cord from the electrical outlet.
7) Do not operate if the plug or wire is damaged.
8) Verify that hands are dry prior to disconnecting the Power.
9) To reduce the risks of electrocution, keep all Connections dry.
10) For indoor use only.
11) If any of the electrical components get wet, unplug Immediately.
12) Do not use soaps or detergents when cleaning this device.Thoroughly clean and
rinse with warm water and make sure the device is completely dry before
connecting.
13) Keep this product away from children.
Note: the MAXFLOW unit should always be fully submerged when there is power to
the Unit. If the unit has power and is not fully submerged, permanent failure
to the Unit can occur not covered by the warranty.
1 2
MODEL DIMENSIONS MAX HEAD FLOW-RATE OUTLET POWER
NP-80 1 ¾" X 1 ¾" X1 ¼" 22" 80 GPH ⅜" ,½" 4 WATT
NP-302 2" X 1 ½" X 2" 22" 118 GPH ½" 7 WATT
NP-305 3 ¼" X 2 ½" X3 ½" 22" 317 GPH ½" 18 WATT
NP-306 4 ¼" X 2 ¾" X3 ¾" 22" 496 GPH ½" 35 WATT
AQUATOP 1 YEAR LIMITED WARRANTY
Products are guaranteed by AQUATOP® Aquatic Supplies to the original purchase-
against defective material and workmanship under normal use for a period of 1 year
from the date of the original purchase through an Authorized Aquatop Reseller.
Products have no warranty if:
1.) The product has been serviced, modied or tampered with by
anyone other than AQUATOP Aquatic Supplies,
2.) The product has been abused or damaged (including broken or
cracked bulbs), and/ or
3.) The product has been transported without proper packaging,
4.) The product was purchased from an Unauthorized Reseller.
Note: All sales from Amazon and Ebay (regardless of seller) do not qualify for
any warranty coverage.
Please see www.aquatop.com for more information.