Arachnid Chuck A Luck User manual

Unpacking and Assembly Instructions
These instructions describe how to properly unpack and assemble the Chuck-A-Luck Darts
machine. These instructions are for the first assembly only. Assembly is easier with two or
more people.
Unpacking
Carefully unpack all the parts for the Chuck A Luck Darts machine. Take care when removing the
box and wrapping. Some of the parts may be damaged by knives. Check over the parts you
have laid out against the parts list below.
Parts List
Item Description Qty
ABase w/ 3 Casters Attached 1
B Motor Housing: Contains Motor and Parts Box (Item G) 1
C Darthead Hub 1
D Darthead Arms Assembly 4
EDrape Support 1
F Numbered Rings 4
G Parts Box: Contains Lamps (Item I) 1
H Drape 1
I Lamps 2
J69” Metal Poles 2
AC
B
E
I
D
J
H
G
F

Installing the basic frame and hub
1. Place the base on the ground so that it is resting
on the casters. Make sure to lock the two front
casters so that they do not roll around.
2. Place the motor case onto the base with the dart
head hub pointed toward the front.
3. Secure the motor case to the base using the
four 5/16” x 1/2” bolts provided.
4. Press in and hold the spring buttons at the bottom of the drape
support.
5. While holding the spring buttons, insert the drape support into
the holes provided on the back of the motor case. Make sure
that the drape support slides all the way through. It is easier to
put the drape on while the drape support is in this position.
6. Hang the top of the drape over the drape support.
7. Feed one of the 69” poles through the
loops at the top. Make sure it goes
through both loops and under the drape
support.
Tools Needed
1 - 1/2” Combination Wrench - Used for attaching the
Motor Case to the Base. Included.
1 - Hex Key Set - Used for attaching the darthead hub and for
adjusting the darthead clamp bar. Included.
Front

8. Remove the darthead hub from the motor case.
Make sure to detach the phone cable from the
smart target board inside the hub first.
9. Feed the axle shaft through the drape opening.
10.Replace the darthead hub and secure tightly to
the shaft.
11. Slide the other 69” metal pole through one side
of the drape and through the base.
12.Install the display on the top center of the game. Make sure that
it is in the center of the graphic.
13.Install the lamps onto the top of the frame. Plug their power cords
into the outlet provided on the outside of the motor case.
14.Raise the drape support through the second set of holes so that
it rests on the spring buttons.
1. Locate the darthead arms.
2. Open the darthead hub. The guides have an alignment pin
on the lower end of them.
3. Loosen the socket head screws holding the clamp bar in
the darthead hub.
4. Insert the darthead arm, carefully feeding the wires and
connectors through first. Slide it all the way in until it hits the
alignment pin. Lock in place using the clamp bar.
5 Repeat steps 3 and 4 for all four darthead arms.
Installing the Dartheads
6. Plug the black connector at the end of each darthead arm
in to the smart target board. These connectors are keyed
and can only go in one way. The order of the connections
does not matter.
Caution: If you put the connectors in backwards, and push
too hard, you may bend the pins on the Smart Target Board.
7. Close darthead hub when finished.
8. Attach the number rings to each darthead making sure to
align the number 3 so that it is over the darthead arm.

Part # 42427 REV D