Arboria Casablanca User manual

CHECK BOX FOR THESE CONTENTS
Tools you will Need
• Phillips Screwdriver
• One bag of concrete mix
to anchor the arbor
Handy To Have
• Tape Measure
• Cordless Screw Gun
Casablanca Arbor
ASSEMBLY INSTRUCTIONS
TOOLS YOU WILL NEED
PLEASE READ THROUGH BEFORE YOU START ASSEMBLY
9
Cap Pieces (6)
Arches (2)
Lattice Side Panels (2)
Crown Blocks (4) 2 right and 2 left
1
2
3
4
3/4” Wood Screws, bright (20)
3” Wood Screws, gray (12)
1 1/8” Wood Screws, gray (12)
Metal Connecting Straps (4)
Metal Anchor Straps (4)
Spears (2)
HARDWARE

CROWN BLOCKS TO ARCH ASSEMBLY
Step 1
Note: blocks are 2 right hand
and 2 left hand
Align large hole in block
with slot in arch
Attach the crown blocks to the ends of
the arches by using two 3” screws into
Step 2,3,4
Use caps to hold sides and
arch off the ground!
Attach one arch to the side
panels using 2 short metal
straps. Use a 3/4” screw
into the arch only,
not sides
Step 5
Use 3 ” screws
to firmly join arch assembly
ARCH TO THE SIDE PANELS ASSEMBLY
1
2
5
4
3
Caps
Page 2 Volume
1, Issue 1

Step 6
Install the remaining 3/4” screws to the side panel
through the holes in the metal straps
78
9
6
Step 7,8
After attaching the first arch to the side panels, turn the
assembly over by lifting the sides and moving backward.
Attach the second arch, following the same method as
the first arch.
TOP CAPS TO ARCH ASSEMBLY
Step 9
Attach the cap pieces according to the pencil marks on
the arches, using the 1 1/8” screws
TIGHTEN WITH HAND SCREW DRIVER TO
AVOID SPLITTING THE WOOD
Stand the arbor in the upright position.
Make sure that the sides are set square to each other.
Follow the anchoring instructions on the back page to
.Step 10
Insert the spears into the holes on tops of the arches.
Long Page 3

3841 N. COLUMBIA BLVD.
PORTLAND, OR 97217
[phone]
www.arboria.com
INSTALLING THE ARBOR