ARC WBT-913 User manual

Version 1.
pecification:
Function: On / Off / Dimmer
Frequency: 433.92MHz
Battery: 3V CR2032 lithium cell battery (included)
Input Rating: 220V- 240V AC / 50Hz
verview:
Adding extra feature to your existing wired light switch.
Install behind a wall switch to control extra load without worrying to add another wall switch.
Wireless transmission is via 3V CR2032 lithium cell battery.
S
O
Wireless 2 Channel Wall Switch Module
WBT-913

Version 1.
pplication and Wiring:
Switch OFF the mains power before performing any installation.
Connect the module accordingly to diagram below.
Connecting to 1 channel
Wire ‘Live’ intro “L↓” terminal of module.
Wire ‘ ’ intro ‘ ’ terminal of module.
Then wire ‘L↓’ into light switch ‘L’.
Wire ‘ ’ intro output port ‘L1’ of the light switch.
A

Version 1.
You can now control your wired lighting and at the same time controlling extra lighting wirelessly.
Connecting to 2 channel
Wire ‘Live’ intro “L↓” each terminal of module.
Wire ‘ ’ intro ‘ ’ each terminal of module.
Then wire ‘L↓’ together then wire into light switch ‘L’.
Switch 1: Wire ‘ ’ intro S1 output port ‘L1’ of the light switch.

Version 1.
Switch 2: Wire ‘ ’ intro S1 output port ‘L1’ of the light switch.
aring:
Pairing using LEARNING MODE:
1. First choose the desired receiver(s) that you wish to control.
2. Press the ‘Learn’button once (LED will flash), this will now enter learning mode.
3. On the wall switch press the ‘ON’button intended to be paired; the load will flash twice to
confirm that the remote control is now paired.
NOTE: Learning mode lasts for 12 seconds; if no signal is given to the receiver then it will
automatically exit learning mode without pairing the device.
To exit learning mode manually, simply press the ‘Learn’button again.
！If, during learning mode the load does not flash to confirm, this means that the receiver’s memory
is FULL and no further wall switch may be paired unless one of the existing wall switch is first
unpaired (see below).
nparing:
Removing single device:
1. With the receiver that you intent to un-pair press the ‘Learn’button once (LED will flash), this
will now enter learning mode.
P
U

Version 1.
2. On the wall switch press the ‘OFF’button intended to be unpaired; the load will flash twice to
confirm that the wall switch is now unpaired.
peration:
ON/OFF Function:
Press the ‘ON’ button on wall switch, the lights will gradually illuminate.
Press the ‘OFF’ button on wall switch, the light will gradually turn OFF.
Dimming Function:
1. Make sure the load (light) is switched ON.
2. On the wall switch press the ON button again, the loads will start to dim.
3. To stop at the desired brightness level, press the ON button again.
※ Dimming level dims in cycle, during the cycle if no signal is given『with 4 cycles it will stop at
100% brightness』.
！After setting a dim level using the wall switch the light is then switched OFF, the next time that
the light is switched back ON again the load (light) will return to the previous stipulated brightness.
attery Replacement:
3V CR2032 lithium battery is included.
When the battery voltage is low, the transmission range will be reduced accordingly.
Take out battery compartment and replace fresh new CR2032 cell battery.
roubleshoot:
Problem:I cannot pair my wall switch with the receiver.
Solution:The memory on receiver is full, please delete one or more memory and try pairing again.
O
B
T