Argo soul digit User manual

11
V 05/16
OPERATING INSTRUCTIONS
Read the instructions carefully before installing and operating the appliance or performing
maintenance operations. Observe all the safety instructions; failure to observe the instructions may
cause accidents and/or damages. Store these instructions for future reference.
ELECTRIC CONVECTOR
EN

12
V 05/16
GENERAL SAFETY INFORMATION
Use this convector only as outlined in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock or injury to people.
Ensure that the mains power complies with the voltage specified on
the convector data plate (220-240V~/50Hz).
This appliance can be used by children aged from 8 years and
above and people with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children
without supervision.
This product is not a toy. Children under the age of 3 years must be
kept out of reach unless properly supervised, to ensure that they do
not play with the appliance.
Children aged between 3 and 8 years must only be able to turn the
appliance on/off, provided that the appliance has been placed in its
normal operating position, that instructions have been given on how
to use the equipment safely, and that its risks have been
understood.
Children aged from 3 years and les than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
CAUTION - Some parts of this product can become very hot
and cause burns. Particular attention has to be given where
children and vulnerable people are present.
WARNING: In order to avoid hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied through and
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
WARNING: do not use the fan heater with a controller or any
other external device that activates the appliance
automatically, as there may be a risk of fire if the fan heater is
covered or incorrectly positioned.
Do not restrict the air inlet and outlet grilles.
The appliance heats up slightly when in use. In order to avoid burns,
do not let bare skin touch hot surfaces.

13
V 05/16
Ensure that all objects are at least 1 meter from the front and sides
of the appliance.
Disconnect the mains power when the appliance is not used or for
cleaning operations.
Avoid using the convector in dusty environments or in the presence
of inflammable vapours (e.g. in workshops or garages) or paint
vapours.
Do not place anything on the appliance, use the appliance to dry
clothing. Use the appliance in a well-ventilated area.
Avoid placing fingers or foreign objects in the air inlet/outlet grilles,
as this may lead to electric shock or fire and may damage the
appliance.
To avoid the risk of fire, do not block the grilles or tamper with them
in any way while the convector operates.
Do not use the appliance if the cord or plug are damaged. If the
power supply cord is damaged, it must be replaced by the service
centre so as to avoid any safety risks.
Do not operate the appliance if it has fallen from a height or has
suffered damage in any way. Contact a service centre to examine
the appliance or perform any electrical or mechanical repairs.
The most common cause of overheating is the build-up of dust in
the appliance. Remove dust deposits by unplugging the appliance
and cleaning the air outlets and grilles with the aid of a vacuum
cleaner.
Do not use abrasive detergents for cleaning this appliance. Clean
the appliance with the aid of a damp (not wet) cloth rinsed in hot
soapy water. Always remove the plug from the mains socket before
cleaning.
To disconnect the convector, push the switch to OFF and remove
the plug from the socket. Pull on the plug only. Avoid pulling on the
cord when disconnecting the convector.
Do not place any objects on the cord and do not bend it.
It is not advisable to use extension cords, as these may overheat
and cause the risk of fire. Do not use a single extension cord to
operate multiple appliances.
Do not immerse the cord, plug or any other element of the appliance
in water or other liquids.
Do not touch the plug with wet hands.
Do not place the convector above or near another heat source.

14
V 05/16
WARNING: AVOID COVERING THE CONVECTOR TO PREVENT IT
FROM OVERHEATING.
The symbol below signals the above warning:
The convector may cause the risk of fire if, while in operation, is
covered by or comes into contact with inflammable material
including curtains, drapery, blankets, etc. KEEP THE CONVECTOR
AWAY FROM THESE MATERIALS.
Do not connect the appliance to the mains power before it has been
properly assembled and positioned.
Do not run the cord under carpets. Do not cover the cord with
blankets, carpets or similar materials. Place the cord far away from
busy areas or where it cannot be accidentally pulled-out.
Do not position the convector below a socket outlet.
Do not operate the appliance outdoors.
WARNING: do not use the convector with a controller or any
other external device that activates the appliance
automatically, as there may be a risk of fire if the convector is
covered or incorrectly positioned.
Do not operate the convector in close proximity to bathtubs,
showers, washbasins or pools.
Upon initial start-up, the convector may emit a slight, harmless
smell. This smell is a normal effect of the initial heating up of the
internal heating elements, and should not recur later on.
WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON
SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER.
WHEN SERVICING OR MOVING THE CONVECTOR, ALWAYS
UNPLUG THE POWER CORD.
A convector has hot and arcing or sparkling parts inside. It must not
be used in potentially dangerous locations such as flammable,
explosive, chemical-laden or wet atmosphere.
Do not place the convector on soft surfaces, like a bed, where
openings may become blocked. Always place the convector on a
stable, flat, level surface when operating, to avoid the chance of the
convector overturning. Locate the power cord so the convector or
other objects are not resting on it.
Always unplug the convector when not in use.
In order to avoid accidents turn unit off if unattended.
In the event of any problems (abnormal noise or a strange smell)

15
V 05/16
switch off the appliance immediately, do not
attempt to repair it and take it to your local after sales service.
DESCRIPTION OF PARTS
FRONT VIEW REAR VIEW
A. Air delivery/air intake grille
B. Feet
C. Side handles
D. Buttons and LCD display
E. Rear holes for wall mounting
F. Remote control
HOW TO INSTALL THE APPLIANCE
The convector can be used as portable appliance, after assembling the feet, or alternatively it can be wall-mounted
using the specific accessories supplied.
A. Portable use: how to assemble the feet supplied.
The convector is packed without feet. These must therefore be assembled before using the appliance.
Assemble the feet as shown in the figure and put the convector in an upright position. Position the unit on a flat,
stable surface. When you move the appliance, use its side handles.
MONTE I PIEDINI IN DOTAZIONE
A
B
D
F
A
E
C

16
V 05/16
B. Wall-mounting: how to mount the convector onto the wall.
The convector packaging contains all the accessories necessary for wall-mounting.
To wall-mount, proceed as follows.
1. Observe the minimum distances from the walls as
pointed out in the picture below.
2. Mark on the wall with a pencil the points where it is
necessary to make the holes in order to insert the Fishers.
3. Drill holes in the wall and insert the 4 Fisher rawlplugs. Screw up 2 of the 4 screws supplied into the 2 upper
rawlplugs, keep the head of the screws out of the Fisher rawlplugs for 8 mm.
4. Install the two spacers in the bottom of the convector as described in the picture.
5.Insert the hooks on the head of the screws, then tighten the screws firmly.

17
V 05/16
6. Insert the rear holes for wall mounting of the convector into the hooks on the wall, then fix the spacers at the
base of the convector.

18
V 05/16
HOW TO USE THE CONVECTOR
Position the unit on a flat, stable surface.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
When you move the appliance, use the handles.
LCD DISPLAY
CONTROL PANEL
Heating mode selection button
ECO/COMFORT/SUPER
Press this button and then the
buttons +/ – in order to select
the mode:
- ECO mode: reduced power to
save energy (750W).
- COMFORT mode: medium
power (1250W).
- SUPER mode: maximum power
(2000W).
TIMER button
When the appliance is operating, the operating time can be
set by touching this button: the timer display lights and
shows 0 and pressing the buttons +/- you can set the
desired time, between 0,5 and 24 hours, with each touch
corresponding to half an hour.
Press and hold the button + or - for 2 seconds in order to
increase/decrease the timer quickly.
The display shows the set time. The unit will switch off
automatically at the end of the programmed time.
In order to switch it on again press the button ON/OFF .
If a TIMER is set the LCD display shows the symbol .
Buttons + and -
Allow you to adjust the mode
(ECO, COMFORT, SUPER), the
temperature and timer settings of
the appliance.
ON/OFF button
Touching the ON/OFF button the
appliance will begin to operate and the
symbol appears on the LCD
display. Touching the button ON/OFF
once again the appliance will switch off
and the symbol disappears.
TEMPERATURE button
When the appliance is operating, touching this button will
allow you to set the temperature: the display will show
ambient temperature in °F and pressing again this
button in °C. Pressing the buttons + and - , the desired
temperature can be set between 5 and 37°C (41 – 99 °F).
Press and hold the button + or - for 2 seconds in order to
increase/decrease the temperature quickly. After 5” the
display will show the ambient temperature once again.
When the set temperature is 2°C below the room
temperature, the convector starts heating.
NOTE – The default temperature is 24°C –
75°F.
FORCED VENTILATION button
(TURBO function)
TIMER display FORCED
VENTILATION
display
TEMPERATURE
display
(°C or °F)
ECO/COMFORT/
SUPER mode
display
Convecto
r
symbol ON
display
Display on if the
room
temperature is
below 5°C
LED POWER ON: the power
supply is connected.

19
V 05/16
WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.
WHEN YOU TURN THE APPLIANCE ON AGAIN, AFTER SWITCHING IT OFF YOU HAVE TO RESET ALL
FUNCTIONS AGAIN.
REMOTE CONTROL
The remote control uses Lithium/Manganese button cells, model no. CR2025 -3 V, compliant with Battery Directive no.
2006/66/CE (supplied with the remote control).
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below)
Open the battery cover at the rear of the remote control (press and pull the cover).
Place the battery into the cover, observing the correct polarity. Insert the cover onto the remote control.
OVERHEATING SAFETY DEVICE
In case of overheating the safety cut out protecting the heating element will automatically switch off the convector.
In this case the convector stops working.
If this happens:
select SUPER mode (maximum power);
it the problem persists, switch off the convector;
remove the causes of abnormal operation or overheating (i.e. obstacles in front of air inlet or air outlet grille, abnormal
accumulations of dusts inside the appliance);
let the convector cool down for 15/20 minutes;
switch on again the convector and verify the correct operation.
If the fault persists, contact an Authorized Service Center.
ECO/COMFORT/SUPER
mode selection button FORCED
VENTILATION
button
ON/OFF button
+ and -buttons
TEMPERATURE button
TIMER button
Information for correct disposal of the battery in accordance with the European Directive 2006/66/EC
Please replace battery when its electricity charge is used up: please do not eliminate this battery together with normal
household waste. It must be taken to special local community waste collection centres or to a dealer providing this service.
Disposing of a battery separately avoids possible negative effects on the environment and human health deriving from an
inappropriate disposal and enables its components to be recovered and recycled to obtain significant savings in energy and
resources. In order to underline the duty to dispose of this equipment separately, the battery is marked with a crossed-out
dustbin.

20
V 05/16
MAINTENANCE AND STORAGE
ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.
IMPORTANT: DO NOT SUBMERGE THE CONVECTOR IN WATER.
Cleaning the outside surface of the appliance
Turn the switch off and unplug before carrying out any maintenance work or moving the appliance.
Use a soft cloth to remove any dust from the convector.
If the convector is excessively dirty, use a soft cloth moistened with water and a mild detergent at a temperature lower
than 50°C. Let the convector dry completely before use.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils,
chemical substances or other items to clean that may damage the surface.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
STORAGE
If the appliance is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a
cool and dry place.
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE EUROPEAN DIRECTIVE
2012/19/EU
At the end of its working life this equipment must not be disposed of as an household waste. It must be taken to special local
community waste collection centres or to a dealer providing this service. Disposing of electrical and electronic equipment
separately avoids possible negative effects on the environment and human health deriving from an inappropriate disposal and
enables its components to be recovered and recycled to obtain significant savings in energy and resources. In order to underline
the duty to dispose of this equipment separately, the product is marked with a crossed-out dustbin.
www.argoclima.com