Argox PT-60 User manual

KEYPADS
1. Charging the Main Batteries at least 16 hours for the first time
2. Please cold rest (press reset and power button simultaneously)
and
make sure system reboot then start to charge.
It may take up to 2 hours to fully charge the empty backup battery.
The first time charge should be for at least 16 hours to insure a
proper charge
 After you have initially charged your device for about 8 hours, the
device is ready to be used. You can now start up your device where
you’ll calibrate the display, learn some basic stylus usage, and set
up the system time zone, date and time.
PT-60 Mobile Computer
Quick Start Guide

Front View Back View
SD Installation
Remove the cover
Stylus
Connector
Touch Screen
Scan Button
Reset Button
Battery Cover Latch
Scan Window
SD Card Cover
Speaker

PT-60 Quick Start Guide
1
2
3
4
5
1. Scan key
2. Cursor key
3. 10-key pad
4. Function key
Battery Cover
http;//www.argox.com
See User Manual for more information
When the Function button is
pressed, an icon appears in
the operation system
Function activated icon
5. Power key
6. ESC key
7. Alpha key
8. Reset
Function key
Use this key to launch applications and select items (show on the keypad in
yellow.
Press the “FUNC” key once to activate this mode followed by another key
Alpha key
Use this key to access the secondary layer of characters and actions.
Press the “Alpha” key once to lock the keypad in the Alpha state
Press the “Alpha” key second time to return to the normal state
7
6
Power Button
8

KEYPADS
Red = Normal charge / Green = Full Charge












Download ActiveSync ® 4.5 or higher from http://www.microsoft.com and follow the instructions to install ActiveSync onto the host
computer.
                   
Support Information
More Information on the PT-60
Visit the Argox Web site http:// www.argox.com
Setting up, Using and troubleshooting the PT-60
PT-60 User’s Manual
Available at http:// www.argox.com
49-P60001-001 Rev. A – November 2008

Single slot Serial / USB Cradle
Spare Battery
Charge LED
Press mobile computer
firmly into cradle
1. Turn the screw
2. Open the cover


 !"#
Be sure to turn the terminal off before you do this
PT-60 Quick Start Guide
Follow the on screen ActiveSync instructions to
establish a connection between the PT-60 and
the host computer.
The PT-60 mobile computer let you link to a
host computer through the CRD-20 cradle for
data communication.
Install or replace the main battery in the terminal
Install or replace the main battery in the gun grip
1. Slide the
main battery compartment cover lock to
the FREE position and remove the cover
2. Load a Li-Polymer
battery pack into the main battery
compartment in the direction shown in the figure
3. Attach the battery compartment cover to the
terminal and slide the main battery compartment
cover lock to the LOCK position.
Charge LED